Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
Search Results "Curb Ramp Bottom Landing"
Filters
Commonly Searched Documents
-
404.2.10 Door and Gate Surfaces
-
11B-404.2.10 Door and gate surfaces
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
-
11B-404.2.10 Door and gate surfaces
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
-
11B-1009.5.4 Transfer steps
The surface of the bottom tread shall extend to a water depth of 18 inches (457 mm) minimum below the stationary water level. [2010 ADAS] Advisory 1009.5.4 Transfer Steps. ...
-
Gripping Surface Cross Section and Clearances M301, M302, and M305.2
Interruptions along the bottom of the transfer support gripping surface will not obstruct more than 20% of its length per ADA and ABA 2004 Guidelines Section 505.6....
-
1009.5.4 Transfer Steps
The surface of the bottom tread shall extend to a water depth of 18 inches (455 mm) minimum below the stationary water level. Advisory 1009.5.4 Transfer Steps....
-
4.15.5(1)
(1) Wall- and post-mounted cantilevered units shall have a clear knee space between the bottom of the apron and the floor or ground at least 27 in (685 mm) high, 30 in (760 mm) wide, and...
-
Extensions
The bottom extension is especially important in providing this support until one is fully vertical....
-
4.15.5(1)
(1) Wall- and post-mounted cantilevered units shall have a clear knee space between the bottom of the apron and the floor or ground at least 27 in (685 mm) high, 30 in (760 mm) wide, and...
-
4.34.6.10* KITCHEN STORAGE
(2) Door pulls or handles for wall cabinets shall be mounted as close to the bottom of cabinet doors as possible....
-
11B-1002.4.3 Gaps
Exception: Where compliance is not operationally or structurally feasible, ramps, bridge plates, or similar devices complying with the applicable requirements of 36 CFR 1192.83(c) shall...
-
Use Zone
designated by ASTM F 1487 (incorporated by reference, see "Referenced Standards" in Chapter 1) for unrestricted circulation around the play equipment and where it is predicted that a user would land...
-
106.5.74 Use Zone
designated by ASTM F 1487 (incorporated by reference, see "Referenced Standards" in Chapter 1) for unrestricted circulation around the play equipment and where it is predicted that a user would land...
-
Conflict with Local Accessibility Codes
One commenter, the Seattle Department of Construction and Land Use, presented an example of how a local accessibility code that is more stringent with respect to some accessibility provisions...
-
Edge Protection: ADA Standard Section 1005.3
In such a design, curbs or barriers are not required....
-
11B-404.2.7 Door and gate hardware
existing glazed doors without stiles, existing overhead rolling doors or grilles, and similar existing doors or grilles that are designed with locks that are activated only at the top or bottom...
-
Cross Slope (R302.6) (Section-by-Section Analysis)
On a sidewalk, cross slope is measured perpendicular to the curb line or edge of the street or highway....
-
11B-247.1.2.6 Reflecting pools
The edges of reflecting pools shall be protected by railings, walls, warning curbs or detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.6. ...
-
4.29.6 Detectable Warnings at Reflecting Pools
The edges of reflecting pools shall be protected by railings, walls, curbs, or detectable warnings complying with 4.29.2....
-
11B-247.1.2.6 Reflecting pools
The edges of reflecting pools shall be protected by railings, walls, warning curbs or detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.6....
-
11B-247.1.2.6 Reflecting pools
The edges of reflecting pools shall be protected by railings, walls, warning curbs or detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.6....
-
11B-101.2 Reserved.
Examples of steps to remove barriers include, but are not limited to, the following actions – 1) Installing ramps; 2) Making curb cuts in sidewalks and entrances; ...
-
Use Zone
designated by ASTM F 1487 (incorporated by reference, see "Referenced Standards" in Chapter 1) for unrestricted circulation around the play equipment and where it is predicted that a user would land...