Car control keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
Search Results "1991 Standards"
Commonly Searched Documents
-
407.4.6.3 Keypads
-
E202.1 General
ICT shall be exempt from compliance with the Revised 508 Standards to the extent specified by E202....
-
E202.4 Federal Contracts
ICT acquired by a contractor incidental to a contract shall not be required to conform to the Revised 508 Standards....
-
E201.1 Scope
ICT that is procured, developed, maintained, or used by agencies shall conform to the Revised 508 Standards....
-
225(d)(1)(B)
(B) establish minimum standards that shall be met in carrying out subsection (c) of this section;...
-
Station platforms
(DOT ADA Standard 810.5.3.)...
-
M18
[ADA Standards § 4.16.5] Yes No...
-
11B-705.1.1.3.1
Detectable warning surfaces shall be yellow and approximate FS 33538 of Federal Standard 595C....
-
§40.3(b)(3)
(3) The alteration of an existing building, or of such portions thereof, to which application of the standards is not structurally feasible....
-
ADMINISTRATIVE AUTHORITY
A governmental agency that adopts or enforces regulations and standards for the design, construction, or alteration of buildings and facilities....
-
§100.201a(b)
(b) The addresses of organizations from which the referenced standards can be obtained appear below:...
-
b. Telephone Communications
Telephone relay services involve a relay operator who uses both a standard telephone and a TTY to type the voice messages to the TTY user and read the TTY messages to the standard telephone...
-
232 Detention Facilities and Correctional Facilities
232 Detention Facilities and Correctional Facilities Section 232 of the 2010 Standards establishes requirements for the design and construction of cells, medical care facilities, and...
-
E.4. - What are examples of issues an agency may wish to consider when drafting a solicitation to acquire EIT?
To be considered eligible for award, offerors must propose goods and/or services that meet the applicable provisions of the Access Board’s standards as identified by the agency....
-
Design Guidelines for the Hearing and Visually-Impaired
To specify visual and auditory design features for individual dwelling units would be to recommend standards beyond those necessary for compliance with the Act....
-
List of Subjects
Revise part 1194 to read as follows: PART 1194 – INFORMATION AND COMMUNICATION TECHNOLOGY (ICT) STANDARDS AND GUIDELINES Sec. 1194.1 Standards for Section 508 of the Rehabilitation...
-
A4.17.3 Size and Arrangement
This section requires use of the 60 in (1525 mm) standard stall (Figure 30(a)) and permits the 36 in (915 mm) or 48 in (1220 mm) wide alternate stall (Figure 30(b)) only in alterations where...
-
3.3.5 Seat Height
3.3.5 Seat Height Height dimension standards for seats prescribed in the Australian, Canadian and U.S. standards were very similar (480 mm or 18.9 in., 480 mm or 18.9 in. and 485 mm...
-
II-4.2000 Relationship among title II and other Federal laws that prohibit employment discrimination by public entities on the basis of disability
What standards are used to determine compliance under title II? For those public entities that are subject to title I of the ADA, title II adopts the standards of title I....
-
11B-210.1 General
[2010 ADA Standards] 2....
-
Introduction
, employment tests or other selection criteria that screen out or tend to screen out an individual with a disability or a class of individuals with disabilities unless the standard, test...
-
5. Interoperability Requirements for Assistive Technology
Compatibility with assistive technology is a foundational concept common to the existing 508 Standards and 255 Guidelines....
-
E202.5 Undue Burden or Fundamental Alteration (Section-by-Section Analysis)
Undue Burden or Fundamental Alteration (Section-by-Section Analysis) This section proposes to retain the provisions in existing 508 Standards §§ 1194.3(e) and 1194.2(a)(1), but would...
-
1.9.1.1.5
1.9.1.1.5 With respect to buildings, structures, sidewalks, curbs and related facilities not requiring a building permit, building standards published in the California Building Standards...