Crank its stable work surface up and the Lift Desk easily accommodates work by a student or teacher in the standing position....
Search Results "Horizontal Standing Support"
- Smith System Lift Desk Work Surface with Crank
- Nana Wall Systems, Inc. Folding Glass Walls Solid Wood WD65
- Rakks® Aria Brackets Installation Video
- Meet Bruce Cast Video (open captions)
-
§1607.5 General standards for validity studies.
The evidence of both the validity and utility of a selection procedure should support the method the user chooses for operational use of the procedure, if that method of use has a greater...
-
Section 1630.9 Not Making Reasonable Accommodation
The term “supported employment,” which has been applied to a wide variety of programs to assist individuals with severe disabilities in both competitive and non-competitive employment, is...
-
The Brewer Company, LLC
It is certain that the addition of transfer supports and leg supports will add to the product cost....
-
Birthing Room Bath Tub Accessibility
I was surprised to find that the highlighted selection supports the Owner's desire not to provide a seat or grab bars to the bathtub in a birthing room that has an accessible shower....
-
NFPA
unfinished attic or an exterior wall, smoke alarms and smoke detectors shall be mounted on an inside wall. 4) Smoke alarms or smoke detectors shall be installed a minimum of 20 feet horizontal...
- Moen Fold Down Shower Seat
-
Section 1193.35 Redundancy and Selectability [1193.33 in the NPRM] (Section-by-Section Analysis)
Although this provision was supported by persons with disabilities, it may run contrary to section 1193.41 (i), which intends to make products accessible to persons with limited cognitive...
-
604.8.1.4 Toe Clearance
provide a toe clearance of 9 inches (230 mm) minimum above the finish floor and 6 inches (150 mm) deep minimum beyond the compartment-side face of the partition, exclusive of partition support...
-
Purpose
In support of this effort, the Department is announcing its intention to adopt standards consistent with Parts I and III of the 2004 ADAAG as the ADA Standards for Accessible Design. ...
-
Purpose
In support of this effort, the Department is announcing its intention to adopt standards consistent with Parts I and III of the 2004 ADAAG as the ADA Standards for Accessible Design. ...
-
T202 Accessible Means of Boarding and Alighting
Only two commenters expressed views on this scoping section, and both supported the Access Board’s inclusion of requirements for level boarding bus systems....
-
504.2 Content Creation or Editing
edit content that conforms to all Level A and Level AA Success Criteria and all Conformance Requirements in WCAG 2.0 (incorporated by reference in Chapter 1) for all features and formats supported...
-
Clear Floor Space [4.2.4]
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support....
-
Epilogue
legislative successes offering momentum; legal and lobbying expertise in the disability community; the willingness of persons with disabilities to unite for a common cause; the cautious support...
-
Section 36.208(a) (Section-By-Section Analysis and Response to Comments)
Commenters representing individuals with disabilities generally supported this provision, but suggested revisions to further limit its application....
-
A. Existing 508 Standards and 255 Guidelines (1998-2000)
functional performance criteria for covered information and technologies; require agencies to document undue burden determinations when procuring covered products; and mandate accessibility of support...
- Acoustiguide Custom Multimedia Content Application
- Abilitree - Bend, OR
- Meet Bruce Cast Video (open captions with audio introduction)
- AJW Architectural Products US130-A Series US130-A12 12" Exposed Flange, 1.5" Diameter Security Grab Bar - Configuration A
