A utility sink is deeper than a standard restroom basin or kitchen sink and can be used to clean large pots or equipment....
Search Results "Kitchen Clearance"
-
Utility Sinks
-
1136A.1 Receptacle heights
If the reach is over a physical barrier or an obstruction (for example, a kitchen base cabinet), receptacles shall be located within the reach ranges specified in Section 1138A.3....
-
Dispersion: ADA Standard Section 224.5
Section 224.5 covers scoping requirements in the current ADA Standards for dispersion of transient lodging guest rooms.
-
11B-224.5 Dispersion
purposes of the application of this section, the term "sleeping room" is intended to be used interchangeably with the term "guest room" as it is used in the transient lodging standards. 1) Kitchens...
-
11B-224.5 Dispersion
purposes of the application of this section, the term "sleeping room" is intended to be used interchangeably with the term "guest room" as it is used in the transient lodging standards. 1) Kitchens...
-
602 Drinking Fountains
Substantive changes to this section include: removal of references to water coolers (602.1) requiring all wheelchair accessible drinking fountains to provide knee and toe clearance...
-
Footrests and Armrests
This clearance is needed for people transferring between the lift and a mobility device....
-
604.8.2.2 Doors
Toilet compartment doors, including door hardware, shall comply with 404, except that if the approach is to the latch side of the compartment door, clearance between the door side of the...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Figure 608.2.3 Alternate Roll-In Type Shower Compartment Size and Clearance ...
-
Wheelchair Passage Width [4.2.1] and Passing Space [4.2.2]
Additional clearance is needed for maneuvering and sway....
-
Fur out the wall
Just need to make sure all other clearances, (42" from center line to adjacent wall/fixture is clear, etc.) ...
-
608.2.2 Standard Roll-In Type Shower Compartments
Figure 608.2.2 Standard Roll-In Type Shower Compartment Size and Clearance...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Note: inside finished dimensions measured at the center points of opposing sides Figure 608.2.3 Alternate Roll-In Type Shower Compartment Size and Clearance...
-
1009.4.1 Clear Deck Space
Where two grab bars are provided, the clear deck space shall be centered on the clearance between the grab bars. Figure 1009.4.1 Clear Deck Space at Transfer Walls...
-
E2-c
Are any interior stairs along these routes configured with a cane-detectable warning or a barrier that prevents travel into the area with less than an 80-inch high head clearance so that...
-
11B-1009.4.1 Clear deck space
Where two grab bars are provided, the clear deck space shall be centered on the clearance between the grab bars. FIGURE 11B-1009.4.1 CLEAR DECK SPACE AT TRANSFER WALLS...
-
11B-604.8.2.2 Doors
Toilet compartment doors, including door hardware, shall comply with Section 11B-404, except that if the approach is to the latch side of the compartment door, clearance between the door...
-
304.3.2 T-Shaped Space
The space shall be permitted to include knee and toe clearance complying with 306 only at the end of either the base or one arm....
-
Width [4.3.3.] and Passing Space [4.3.4]
However, the minimum width of hallways and corridors is often further determined by ADAAG requirements for clear floor space at elements such as drinking fountains, door maneuvering clearances...
-
68.30(3) Van Accessible Parking at Garages Constructed Prior to April 1994
Parking garages where construction was started before April 1, 1994, and the existing vertical clearance of the garage is less than 98”, are exempted from requirements to have van-accessible...
-
803 Dressing, Fitting, and Locker Rooms
In the proposed rule, an exception to this provision noted that a portion of this space (6 inches maximum) could extend under partitions or openings without doors that provide toe clearance...
-
805 Medical Care and Long-Term Care Facilities
Commenters opposed this requirement, noting that it is inconsistent with specifications for wheelchair turning space in section 304 which recognize knee and toe clearances for specified...
-
Wheelchair Turning Space [4.2.3]
Overlapping Fixed Elements Fixed elements can overlap turning space if required knee and toe clearances are provided....
-
III-4.4300 Standards to apply
However, because of space constraints, he is unable to widen the door to the full 32-inch clearance required for alterations under ADAAG....