Transfer onto these types of diagnostic equipment must be made from either long side, similar to the side transfer surface described above....
Search Results "Curb Ramp Surface"
Filters
Commonly Searched Documents
-
(2) Transfer Surface Location for Diagnostic Equipment Used in the Seated Position
-
Pilot Rock XT Series Side Accessible Picnic Table Using Aluminum
OPTIONAL: To anchor table to a concrete surface, use Model ANC6-4 Anchor Kit (Concrete Screws) and Model ANG-3 Anchor Kit (Anchor Straps)....
-
Pilot Rock WXT and WXTH Picnic Table Using Aluminum
OPTIONAL: To anchor table to a concrete surface, use Model ANC6-4 Anchor Kit (Concrete Screws) and Model ANG-3 Anchor Kit (Anchor Straps)....
-
Pilot Rock WUT and WUTH Picnic Table - Using Aluminum
OPTIONAL: To anchor table to a concrete surface, use Model ANC6-4 Anchor Kit (Concrete Screws) and Model ANG-5 Anchor Kit (Anchor Straps)....
-
Pilot Rock XT Series Side Accessible Picnic Table Using Recycled Plastic
OPTIONAL: To anchor table to a concrete surface, use Model ANC6-4 Anchor Kit (Concrete Screws) and Model ANG-3 Anchor Kit (Anchor Straps)....
-
§ 38.125(b)(6) Platform surface
(6) Platform surface. The lift platform surface shall be free of any protrusions over 1/4 inch high and shall be slip resistant....
-
Check-Out Aisles [7.3]
Writing surfaces must be 36 inches maximum from the floor....
-
Problem Three (Accessible Route)
Solution: Install a portable ramp....
-
UltraPlay Getting Started Installation Video
Learn how to get started and prepare for the installation of your UltraPlay playground structure with this first of several installation videos.
-
AccessRec AccessMat Beach Access Mat System
Comfortable and Safe Developed specifically for pedestrian traffic, AccessMat™ provides a barefoot friendly surface for beach goers....
-
Poured in Place Rubber
The surface cost for PIP ranged from $6.59/sq. ft. to $19.80/sq. ft. ...
-
The Brewer Company, LLC
Company, LLC Minority Report The Brewer Company, LLC 01-Oct-2013 Final Report Medical Diagnostic Equipment Accessibility Standards Advisory Committee Section 5.1.3 Transfer Surface...
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
No public comments were submitted on this issue, but the MDE Advisory Committee voiced concern about surface hazards stating, “gripping surface configurations must provide an effective and...
-
5.1.1 Transfer Surface Height Adjustability
5.1.1 Transfer Surface Height Adjustability. The transfer surface should have an adjustable height in small virtually continuous increments....
-
Priority 2: Access to Goods & Services
Word Fillable Form (2.5MB) Word Non-Fillable Form (2.4MB) PDF Non-Fillable Form (1.4MB)
-
1003.3.2 Boarding Pier Clearances
The following example applies to a boat launch ramp boarding pier: A chain of floats is provided on a launch ramp to be used as a boarding pier which is required to be accessible by 1003.3.2...
-
11B-1003.3.2 Boarding pier clearances
The following example applies to a boat launch ramp boarding pier: A chain of floats is provided on a launch ramp to be used as a boarding pier which is required to be accessible by 1003.3.2...
-
III-6.2000 Alterations: Path of travel
ILLUSTRATION 3: Installing a new floor surface in a factory work room is an alteration to a primary function area, but installing a new floor surface in the corridor leading to the work...
-
4.3.3 Slope
When the surface is not paved or is not elevated above the natural ground, slopes not steeper than 1:33 (3 percent) shall be permitted where necessary for drainage. ...
-
Detecto BRW1000 Portable Wheelchair Scale
The heavy-duty (yet light-weight) 75-lb platform with integral two-way-access ramps, non-skid rubber mat, and 1,000-lb capacity makes this scale perfect for patients in manual or power wheelchairs...
-
5.1.2 Transfer Surface High Height
5.1.2 Transfer Surface High Height. The transfer surface should have an adjustable height range with an upper height measuring at least 25 inches....
-
1.5 Materials
Four different colors of simulated sidewalk surfaces were used in this study....
-
Avoid the extremes of surface reflectivity and contrast (slides 11 and 13)
We don’t have to have highly reflective surfaces that will still reflect light but spread it, diffuse that light instead of pinpoint reflections....
