You also can give feedback that will help FHWA continue to provide useful assistance....
Search Results "Continuous Width"
Commonly Searched Documents
- U.S. Department of Transportation: Self-Evaluation Basics
- Tom Olin: Activist Photographer of the Disability Rights Movement
- Tork Foam Soap Dispenser, Stainless Steel
- AJW Architectural Products UJ11 Series UJ11A Coat Hook Strip 24"L, 3 Hooks - Surface Mounted
- EVAC+CHAIR® 600H Stair Evacuation Chair with Lift Handles
- BTX Intelligent Fashion Motorized Roller Shades
-
11B-403.3 Slope
A sloping sidewalk with a running slope in excess of 5% is excluded from ramp requirements for landings and handrails but it must comply with cross-slope and width requirements. ◼...
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. [2010 ADAS] Advisory 809.2.2 Turning Space. ...
-
1007.2 Accessible Routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (815 mm) minimum. 3....
-
603.2.3 Door Swing
Additionally, the door swing cannot reduce the required width of an accessible route. Also, avoid violating other building or life safety codes when the door swing is reversed....
-
603.2.3 Door Swing
Additionally, the door swing cannot reduce the required width of an accessible route. Also, avoid violating other building or life safety codes when the door swing is reversed....
-
1007.2 Accessible Routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (815 mm) minimum. 3....
-
Guidelines for Requirement 3
For doors within individual dwelling units, the Department has retained, in the final Guidelines, the design specification that a door with a clear opening of at least 32 inches nominal width...
-
603.2.3 Door Swing
Additionally, the door swing cannot reduce the required width of an accessible route. Also, avoid violating other building or life safety codes when the door swing is reversed....
-
Recessed Lavatories
Recessed Lavatories Recessing lavatories can provide space for side transfers while allowing a narrower room width....
-
Treads and Risers [4.9.2], Nosings [4.9.3]
Uniformity is important not only between steps but along each step; curved stairs, where the width of each tread varies, do not meet this requirement....
-
F216.13 Trailhead Signs
The technical requirements in 1017.11 require the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and minimum...
-
Station 4-Acceleration
judge whether gaps in oncoming traffic provide sufficient time to cross the roadway safely, based on the speed of oncoming motor vehicles, their own acceleration capabilities, and the width...
-
1016.1 General
The technical requirements address the surface of outdoor recreation access routes, passing spaces, and resting intervals (1016.2); the clear width of outdoor recreation access routes (1016.3...
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. [2010 ADAS] Advisory 809.2.2 Turning Space....
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. Advisory 11B-809.2.2 Turning space....
-
M303.2.3 Depth (Section-by-Section Analysis)
(Significant Changes – Width and Depth of Wheelchair Spaces)....
-
How to Measure Transfer Surface Height
The lower wheelchair illustrates a typical diagonal transfer.24 Figure 11: Corner radii of a medical examination table The depth and width are measured along the centerlines of...
-
1134A.7 Water closets
The minimum floor space provided at a water closet shall be 48 inches (1219 mm) in clear width. ...
