Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
Search Results "Horizontal Position"
-
1010.1.5 Floor elevation
-
Shane Gillis Net Worth: A Closer Look at the Comedian’s Earnings and Career Growth
Touring across different cities and selling out shows has further strengthened his financial position....
-
Surfaces (R302.7) (Section-by-Section Analysis)
Horizontal openings in gratings and joints must not permit the passage of a sphere more than 13 millimeters (0.5 inch) in diameter....
-
408.4.1 Car Dimensions and Doors
Car doors shall be positioned at the narrow ends of cars and shall provide 32 inches (815 mm) minimum clear width. EXCEPTIONS: 1....
-
Automatic Door Break Out Openings
The minimum clear opening width for automatic doors is measured with all leaves in the open position....
-
Conclusion
Such ANPRMs had no force or effect of law, and no party should rely upon them as presenting the Department of Justice’s position on these issues....
-
Reasonable Accommodation
facilities used by employees readily accessible to, and usable by, an individual with a disability; job restructuring; modifying work schedules; reassignment to a vacant position...
-
1134A.4 Sufficient maneuvering space
The clear maneuvering space shall allow the user to position a wheelchair or other mobility aid clear of the path of the door as it is closed and to permit use of fixtures....
-
604.5.2 Rear Wall
Where an administrative authority requires flush controls for flush valves to be located in a position that conflicts with the location of the rear grab bar, then the rear grab bar shall...
-
1133B.2.5.1
If the door has a closer, then the sweep period of the closer shall be adjusted so that from an open position of 70 degrees, the door will take at least 3 seconds to move to a point 3 inches...
-
1002.2 Accessible Routes
Steeper slopes are permitted on accessible routes connecting the amusement ride in the load and unload position where it is "structurally or operationally infeasible."...
-
A4.30.1 General
Thus, signage positioned perpendicular to the path of travel is easiest for them to notice....
-
1.4.3. Notice Requirements
Despite this change, the Department maintains its position that any costs associated with the notice requirement are de minimis because indicating the availability of captioning and audio...
-
Tandem Bicycles
Tandem Bicycles Tandem bicycles (often called tandems) have positions for two cyclists; typically, the front rider (the "captain") is responsible for steering, balance, shifting,...
-
Epilogue
A whole host of circumstances worked in its favor: effective leadership; advocates in key government positions; the rightness of the cause; the mobilization of the grassroots disability...
-
Publicizing the ADA: Advocacy and the Government Response
As a consequence, ADA advocates successfully positioned the ADA for serious introduction in 1989....
-
4.20.2 Floor Space
floor space in front of a bathtub required by ADAAG (30"-48" min depth depending on the direction of travel by the length of the tub including a seat at the head of the tub) is based on positioning...
-
Limited-Use/ Limited-Application Elevators [§408]
requirements for doors and referenced ANSI/BHMA Standards for low-energy doors, and remain open for at least 20 seconds) Requirements are not included for door timing and delay or for car position...
-
Error/Omission: The door to the toilet room swings into the required clear floor space at accessible fixtures, controls, and dispensers.
For example, if a person using a wheelchair is positioned in the clear floor space at the paper towel dispenser and that clear floor space overlaps the space needed to swing the door open...
-
Section 35.130(h) Safety. (Section-by-Section Analysis)
To ensure consistency between the title II and title III regulations, the Department has added a new § 35.130(h) in the final rule incorporating this longstanding position relating to imposition...
-
1002.2 Accessible Routes
Steeper slopes are permitted on accessible routes connecting the amusement ride in the load and unload position where it is "structurally or operationally infeasible."...
-
1002.5 Amusement Ride Seats Designed for Transfer
Amusement ride seats designed for transfer shall comply with 1002.5 when positioned for loading and unloading. Advisory 1002.5 Amusement Ride Seats Designed for Transfer....
-
1002.2 Accessible Routes
Steeper slopes are permitted on accessible routes connecting the amusement ride in the load and unload position where it is "structurally or operationally infeasible."...
-
AJW Architectural Products U711 Series 16"W x 20"H Channel Frame Mirror - Plate Glass Surface
Back: #20 ga pre-plated galvanized steel, with embossed horizontal louver mounting brackets....
