Nominal seat height is 18”. The WXTH Series offers clearances under the table top of 30” wide, 31” high and 24” total knee and toe clearance (19” knee and 5” toe). ...
Search Results "Closer Height"
-
Pilot Rock WXT and WXTH Picnic Table Using Aluminum
-
Pilot Rock WUT and WUTH Picnic Table - Using Aluminum
Nominal seat height is 18”. The WUTH Series offers clearances under the table top of 30” wide, 31” high and 24” total knee and toe clearance (19” knee and 5” toe). ...
-
1132A.4.1 Thresholds
Changes in height at interior door thresholds (e.g., floor material changes at door thresholds) shall not exceed ½ inch (12.7 mm). Thresholds shall comply with the following:...
-
Accessible Courtroom Stations
Other applicable specifications include accessible work surface heights and toe and knee clearance....
-
607 Bathtubs
Changes made to this section include: revision of grab bar mounting heights (607.4) integration of provisions for grab bars specific to residential dwelling units that were...
-
4.31.2 CLEAR FLOOR OR GROUND SPACE
Figure 44 Mounting Heights and Clearances for Telephones...
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
Pressalit Care PLUS - Bathroom Product Range Overview
A modern, aesthetically pleasing and functional system including horizontal and height and adjustable basins, support arms, shower seats and controls making it ideal for adaptive living...
-
Measures and Procedures
Measures and Procedures A custom-built modular, transfer station was designed and built and consisted of a height adjustable platform capable of a range between 10” to 29” with increments...
-
11B-604.8.1.2 Doors
Note that in Figure 11B-404.2.4.1 (c) the front approach requires 12 inches of strike-side clearance on the push side where a door has both a latch and a closer. ...
-
11B-604.8.1.2 Doors
Note that in Figure 11B-404.2.4.1 (c) the front approach requires 12 inches of strike-side clearance on the push side where a door has both a latch and a closer....
-
11B-810.4 Bus signs
In addition, to the maximum extent practicable, bus route identification signs shall comply with Section 11B-703.5.5 _|Character Height|_....
-
809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
Alteration
, resurfacing of circulation paths or vehicular ways, changes or rearrangement of structural parts or elements, and changes or rearrangement in the plan configuration of walls and full-height...
-
809.5.5.2 Identification
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
106.5.5 Alteration
resurfacing of circulation paths or vehicular ways, changes or rearrangement of the structural parts or elements, and changes or rearrangement in the plan configuration of walls and full-height...
-
R305.1.1 Dome Size
have a base diameter of 23 mm (0.9 in) minimum and 36 mm (1.4 in) maximum, a top diameter of 50 percent of the base diameter minimum and 65 percent of the base diameter maximum, and a height...
-
407.8.2.2 Obstructed Side Reach
Where the operable part is located more than 10 inches (255 mm), but not more than 24 inches (610 mm), beyond the vertical reference plane, the height of the operable part shall be 46 inches...
-
1132A.1 Primary entry doors and required exit doors
The width and height of primary entry doors and all required exit doors shall comply with Section 1126A.1....
-
Intensity
walls and ceiling) must be of an intensity that will raise the overall light level sharply, but not be so intense as to be unsafe for direct viewing when installed at a specified mounting height...
-
A7. Curb Ramps
[ADA Stds 4.7.2] Note: 1:12 is one inch of vertical height for each 12 inches in length. Yes _____ No _____...
-
11B-810.4 Bus signs
In addition, to the maximum extent practicable, bus route identification signs shall comply with Section 11B-703.5.5 _|Character Height|_....
-
"Alteration"
resurfacing of circulation paths or vehicular ways, changes or rearrangement of the structural parts or elements, and changes or rearrangement in the plan configuration of walls and full-height...
-
General: ADA Standard Section 226.1
Section 226.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dining surfaces and work surfaces.
