Floor or ground surface within required maneuvering clearances shall comply with Section 11B-302. Changes in level are not permitted. Exceptions: 1. ...
Search Results "Clear Floor Area"
Filters
Commonly Searched Documents
-
11B-404.2.4.4 Floor or ground surface
-
11B-404.2.4.4 Floor or ground surface
Floor or ground surface within required maneuvering clearances shall comply with Section 11B-302. Changes in level are not permitted. Exceptions: 1....
-
4.2 Q. What if new public and common use spaces are also being added?
If new public and common use areas or buildings are also added, they are required to be accessible....
-
9.2.2(6)
(6) Where provided as part of an accessible unit, sleeping room, or suite, the following spaces shall be accessible and shall be on an accessible route: (a) the living area....
-
Reese Enterprises, Inc. PERFEC MATv * Aluminum Hinge
They offer solid footing and abrasive surfaces, and they are available in a variety of materials and colors to complement any entry area....
-
R405.1 General
Where space beneath an element is included as part of a clear space, the space shall comply with R405....
-
Wheelchair Storage Space: ADA Standard Section 1002.5.4
Wheelchair storage spaces complying with 305 shall be provided in or adjacent to unload areas for each required amusement ride seat designed for transfer and shall not overlap any required...
-
11B-703.5.6 Height from finish floor or ground
Visual characters shall be 40 inches (1016 mm) minimum above the finish floor or ground....
-
11B-1002.5.4 Wheelchair storage space
Wheelchair storage spaces complying with Section 11B-305 shall be provided in or adjacent to unload areas for each required amusement ride seat designed for transfer and shall not overlap...
-
11B-703.5.6 Height from finish floor or ground
Visual characters shall be 40 inches (1016 mm) minimum above the finish floor or ground. Exceptions: 1. ...
-
16.1 Q. Will a standard hung 32-inch door provide sufficient clear width to meet the requirements of the Fair Housing Act?
No, a 32-inch door would not provide a sufficient clear opening to meet the requirement for usable doors....
-
8.5 Stacks
Minimum clear aisle width between stacks shall comply with 4.3, with a minimum clear aisle width of 42 in (1065 mm) preferred where possible....
-
8.5 STACKS
Minimum clear aisle width between stacks shall comply with 4.3, with a minimum clear aisle width of 42 in (1065 mm) preferred where possible....
-
407.2.3.1 Floor Designation
407.2.3.1 Floor Designation. Floor designations complying with 703.2 and 703.4.1 shall be provided on both jambs of elevator hoistway entrances....
-
Can People with Limited Mobility Use the Usable Circulation Path by Themselves?
A person using a wheelchair is able to travel unassisted through that portion of the usable circulation path necessary to reach an area of refuge....
-
Boarding Pier Clearances: ADA Standard Section 1003.3.2
Boarding piers at boat launch ramps shall provide clear pier space 60 inches (1525 mm) wide minimum and shall extend the full length of the boarding pier....
-
5.1.3 Slope
The slope of the surface of the clear floor or ground space inside the camp shelter shall not be steeper than 1:48 (2 percent) in all directions....
-
General
The 1991 Standards require areas of rescue assistance or horizontal exits in facilities with levels above or below the level of exit discharge....
-
Pemko 193 Slip resistance
Hello ETA, I see that you can ask for slip resistance by adding a coating to the Pemko 193 plate. Any experience with this application? Is this a permanent slip resistance or...
-
Walk-A-Sured Roll-On Anti-Slip Safety Coating System
Great for any foot traffic applications such as ramps, docks, stairs, amusement parks and around slippery wet areas Chemical, solvent and water resistant...
-
3.4.2 ORARs in Viewing Areas
Connections shall be provided between site furnishings and constructed features in viewing areas as well as between accessible viewing areas, parking areas, and accessible common use features...
-
302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge. Carpet edge trim shall comply with 303....
-
302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge. Carpet edge trim shall comply with 303....
