In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
Search Results "MUTCD: Manual on Uniform Traffic Control Devices for Streets and Highways"
-
608.5.3 Alternate Roll-In Type Shower Compartments
-
28 CFR Part 36 Nondiscrimination on the Basis of Disability by Public Accommodations - Movie Theaters; Movie Captioning and Audio Description Final Rule
The rule requires movie theaters to have a specified number of captioning devices and audio description devices based on the number of auditoriums in the movie theater that show digital...
-
Phones
Phones Permanently installed telephones must be equipped with a volume control....
-
Water Hydrants
Water hydrants, including water faucets on posts and handpumps are the outdoor devices from which people obtain drinking water....
- BTX Intelligent Fashion Motorized Roller Shades
- BTX Intelligent Fashion Tumo Drapery System
-
C. Communication Features
Yes __ No __ N/A __ Comments: ________________________________________ Visual notification device for door knocks and phone calls (Cannot be same strobe as the fire alarm strobe unit)...
-
Space Needs
Figure 7 was composed to provide a general idea of the variability observed among participants in 1) the amount of space in front of the platform required by each participant and...
-
Highest and Lowest Heights Obtained
Table 9 shows the 5th, 25th, 50th, 75th, and 95th percentiles for protocols A through C. These data represent the ability of the participants in the study to complete a transfer. The...
-
Verify Electrical
Measure to top or bottom of boxes 11B-308.1.2 Alarm/detector systems. 11B-702 Height of HVAC controls....
-
Verify Electrical
Measure to top or bottom of boxes 11B-308.1.2 Alarm/detector systems. 11B-702 Height of HVAC controls....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, operable parts of controls and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm)...
-
Accessibility Standards in Title II Regulations Issued by DOJ
DOJ's Title II regulations prohibit exclusion from participation in or the denial of the benefits of services, programs, or activities, or other discrimination because a public...
-
Clear Width: ADA Standard Section 404.2.3
Section 404.2.3 covers the current ADA Standards for clear width at manual doors, doorways and manual gates that are part of an accessible route.
-
§ 38.127(c)
(c) Controls and operating mechanisms (e.g., heating and air conditioning controls, lighting controls, call buttons, electrical outlets, etc.) shall be mounted no more than 48 inches, and...
- 309.4 Accessible Low Drinking Fountain Operation
-
§382.57(c)(6)(iv)(B) Tactile symbols
(B) Tactile symbols. Function key surfaces must have tactile symbols as follows: Enter or Proceed key: raised circle; Clear or Correct key: raised left arrow; Cancel key: raised...
-
§382.57(c)(7)(ii) Characters
(ii) Characters. Characters displayed on the screen must be in a sans serif font. Characters must be 3/16 inch (4.8 mm) high minimum based on the uppercase letter “I.” Characters...
-
§382.57(c)(6)(iii) Numeric keys
(iii) Numeric keys. Numeric keys must be arranged in a 12-key ascending or descending keypad layout or must be arranged in a row above the alphabetic keys on a QWERTY keyboard. The...
-
M307 Operable Parts
[See subsections ...]
-
11B-407.4.7.1.4 Visible indicators
Buttons with floor designations shall be provided with visible indicators to show that a call has been registered. The visible indication shall extinguish when the car arrives at the...
-
407.4.7.1.4 Visible Indicators
Buttons with floor designations shall be provided with visible indicators to show that a call has been registered. The visible indication shall extinguish when the car arrives at the...
-
§ 382.57(c)(7)(ii) Characters
(ii) Characters. Characters displayed on the screen must be in a sans serif font. Characters must be 3/16 inch (4.8 mm) high minimum based on the uppercase letter “I.” Characters...
-
§ 382.57(c)(6)(iv)(B) Tactile symbols
(B) Tactile symbols. Function key surfaces must have tactile symbols as follows: Enter or Proceed key: raised circle; Clear or Correct key: raised left arrow; Cancel key: raised...