sign, raised characters and braille floor identification signs that comply with Chapter 11B shall be located at the landing of each floor level, placed adjacent to the door on the latch side...
Search Results "Push Side"
Commonly Searched Documents
-
1023.9 Stairway identification signs
-
Check-Out Aisles and Sales and Service Counters
Where the counter is a split-height counter, this requirement applies only to the customer side of the counter top....
-
1. Public Right-of-Way
Street ("Fillmore") and Steiner Street ("Steiner"); (2) Steiner between Grove Street ("Grove") and Fulton; and (3) the east side of 19th Street one block north of Wawona Street....
-
Guest Rooms
The force for pushing or pulling open a door or gate other than fire doors shall be as follows: 1. Interior hinged doors and gates: 5 pounds (22.2 N) Maximum. 2....
-
Clarification on Standard Roll-In Shower Compliance
with a full opening width on the long side."...
-
Emergency Communication
The ASME A17.1 code (section 2.27) requires provision of a push button labeled "HELP" which, when activated, initiates a call for help and establishes two-way communication....
-
Re: Service Counters
CBC 11B-904.4 does not contain any qualifying language that separates the differing requirements between the employee and customer sides of the counter because this information is contained...
- Allegion LCN 1460 Series Surface Mounted Door Control
- Bradley 3-Station Express Lavatory System MG-3
- Bradley 3-Station Express Lavatory System SS-3N
- Bradley 2-Station Express Lavatory System MG-2
- Bobrick ConturaSeries® Recessed Napkin/Tampon Vendor 25₵, 50₵ and Free Operation B-4706
- Bradley 2-Station Express Lavatory System SS-2N
-
11B-404.2.7 Door and gate hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides....
-
810.6.3 Station Names
Signs shall be clearly visible and within the sight lines of standing and sitting passengers from within the vehicle on both sides when not obstructed by another vehicle....
-
WMD POSITIONS FOR TRANSFER
In the diagram below, the upper wheelchair illustrates a typical side transfer, which may optionally utilize a transfer board....
-
R409.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
810.6.3 Station Names
Signs shall be clearly visible and within the sight lines of standing and sitting passengers from within the vehicle on both sides when not obstructed by another vehicle....
-
406.8 Detectable Warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
11B-806.2.3.1 Personal lift device floor space
The clear space shall extend under the bed parallel to the long side and be adjacent to an accessible route....
-
D2. Clear Passage
Does at least one door or one side of a double leaf door at the accessible entrance provide at least 32 inches clear passage width when the door is open 90 degrees?...
-
Verify Rough Plumbing
Location of toilet flanges from walls. 11B-604.2 Location of lavatory traps from side walls. 11B-606.6 Location of...
-
Verify Rough Plumbing
Location of toilet flanges from walls. 11B-604.2 Location of lavatory traps from side walls. 11B-606.6 Location of...
-
Detail
Participants wanted to experience all sides of the buildings. The models aren’t full rounds....