Emergency controls, including the emergency alarm, shall be grouped at the bottom of the panel.
Search Results "Seat Location"
-
407.4.6.4.2 Location
-
809.2.1 Location
At least one accessible route shall connect all spaces and elements which are a part of the residential dwelling unit. Where only one accessible route is provided, it shall not pass...
-
604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side. The centerline of the water closet shall be 16 inches (405 mm) minimum to 18 inches (455...
-
409.4.6.2 Location
Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall.
- American Standard AquaWash Telescoping Bidet Seat 5900A.05G
-
5.4.1.1 Transfer Support Location for Stretchers
5.4.1.1 Transfer Support Location for Stretchers. The transfer surface for stretchers should be oriented along the long side of the surface....
-
5.4.11 Transfer Support Structural Strength for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.11 Transfer Support Structural Strength for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
B. Survey and Review of Polling Place Locations
the location and continue searching until an accessible location or one that can be made accessible on Election Day can be found....
-
Water Closet Centerline and Seat Height
Water closets are to be located so that the centerline is 16 to 18 inches from the side wall compartment partition (604.2)....
-
Lavatory & Accessory Layouts
The trash receptacle is preferred to be near the door to allow people to pull the door open with a paper towel and drop it into the receptacle before exiting.
-
3.2 Getting on the Table
An accessible table allows for a more thorough exam, as compared to an exam where you remain seated in your wheelchair or on a chair....
-
M305.2.5 Surface Hazards
Transfer supports and surfaces adjacent to transfer supports shall be free of sharp or abrasive components and shall have eased edges.
-
M305.2 Transfer Supports
Transfer supports shall comply with M305.2.
-
M305.2 Transfer Supports (Section-by-Section Analysis)
This is an introductory section. As discussed above in Section IV.E.1. (Significant Changes – Transfer Supports), the Access Board strengthened the transfer support requirements and...
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
The proposed rule did not provide any specific restrictions regarding surface hazards around the transfer supports. No public comments were submitted on this issue, but the MDE...
-
5.4 Transfer Supports
5.4 Transfer Supports.
-
5.4 Transfer Supports Recommendations
5.4 Transfer Supports Recommendations
-
M305.2 Transfer Supports
Transfer supports shall comply with M305.2.
-
§ 35.138(e) Hold-and-release of tickets for accessible seating
(e) Hold-and-release of tickets for accessible seating....
-
4. Seating Plans for Designed Theaters and Future Construction Theaters
Seating Plans for Designed Theaters and Future Construction Theaters The United States has reviewed and specifically approves the auditoria seating plans for the Designed Theaters set...
-
Dispersion of Wheelchair Seating Areas (Section-By-Section Analysis and Response to Comments)
- Dispersal of wheelchair seating areas in theaters will be required only where there are more than 300 seats, rather than in all cases....
-
Vertical Dispersion: ADA Standard Section 221.2.3.2
Section 221.2.3.2 covers scoping requirements in the current ADA Standards for vertical dispersion in assembly areas.
-
11B-221.2.1.5 Stadium-style movie theaters
The required wheelchair spaces shall be located on risers or cross-aisles in the stadium section that satisfy at least one of the following criteria: Located within the rear 60 percent...
-
11B-221.2.1.5 Stadium-style movie theaters
The required wheelchair spaces shall be located on risers or cross-aisles in the stadium section that satisfy at least one of the following criteria: Located within the rear 60 percent...