Sub-Committee Summary of Scope for Recommendations Though sometimes avoided, all patients should have their weight taken as it is a basic screening measurement....
Search Results "Unit of Measurement"
Filters
Commonly Searched Documents
-
Sub-Committee Summary of Scope for Recommendations
-
Sec.36.304(c)(3)
(3) Third, a public accommodation should take measures to provide access to restroom facilities....
-
§ 36.304(c)(3)
(3) Third, a public accommodation should take measures to provide access to restroom facilities....
-
608.2.1 Transfer Type Shower Compartments
Transfer type shower compartments shall be 36 inches (915 mm) by 36 inches (915 mm) clear inside dimensions measured at the center points of opposing sides and shall have a 36 inch (915...
-
Definitions
that a polling place is compliant with the 2010 ADA Standards for Accessible Design (“2010 Standards”) on Election Day, whether such compliance is achieved through permanent architectural measures...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
Future Work
The devices that are on the market to measure roadway roughness are not applicable to sidewalk and pedestrian surfaces because they either use accelerometers to measure the surface profile...
-
UDI
Measurements were made with rulers and tape measures but no information is given on the accuracy and reliability of these techniques....
-
Toilet Rooms and Bathing Rooms: ADA Standard Section 213.2
Section 213.2 covers scoping requirements in the current ADA Standards for toilet rooms and bathing rooms.
-
604.3.1 Size
Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular from the rear wall....
-
1.2.1 Walks and other non - ramp surfaces
When overall running slope for walks is measured according to Section 1.1.3 a recommended tolerance for running slope is +1%....
-
§ 37.151(a)(2)
(2) The entity determines that it cannot make measured progress toward compliance in any year before full compliance is required....
-
405.3 Cross Slope
Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
7.4.6 Tread Obstacles
Tread obstacles on trails shall not exceed 2 inches (50 mm) in height measured vertically to the highest point. ...
-
11B-203.8 Residential facilities
In residential facilities, common use areas that do not serve residential dwelling units required to provide mobility features complying with Sections 11B-809.2 through 11B-809.4 or adaptable...
-
Definitions
that a polling place is compliant with the 2010 ADA Standards for Accessible Design (“2010 Standards”) on Election Day, whether such compliance is achieved through permanent architectural measures...
-
Stabila, Inc. Magnetic Tech Digital Electronic Level Type 96M-2
Electronic measuring technology / Two digital displays / Audible inclination guide / IP 65 Dust and Waterproof / Rare earth magnets for hands free use / Removable shock-absorbing end caps...
-
2013 & 2016 CBC Answer
X3 measurement has no code basis. Both X1 and X2 measurement are acceptable if minimum width of 108 inches are achieved....
-
ADAAG: ADA Standard Section 2004
This of the ADA Standards covers the definition of the 2004 ADDAG.
-
Road Roughness Analysis
The IRI also has an ASTM standard measurement protocol for consistent measurements....
-
11B-604.7.1 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
36 CFR Part 1191 ABA Accessibility Guidelines, Outdoor Developed Areas
Billing Code 8150‒01-P ARCHITECTURAL AND TRANSPORTATION BARRIERS COMPLIANCE BOARD 36 CFR Part 1191 RIN 3014-AA22 Architectural Barriers Act Accessibility Guidelines;...
-
Rollability and Smoothness of Walking Surfaces
There are smoothness measures for road surfaces but no similar measures for walking surfaces....
