ETA Editor's Note Imposing additional requirements regarding characters and colors, the preceding CBC requirements pertaining to elevator hoistway signs are more stringent...
Search Results "Seat Height"
-
11B-407.2.3.2 Reserved
-
407.2.3.2 Car Designations
Destination-oriented elevators shall provide tactile car identification complying with 703.2 on both jambs of the hoistway immediately below the floor designation. Car designations...
-
407.2.3.2 Car Designations
407.2.3.2 Car Designations. Destination-oriented elevators shall provide tactile car identification complying with 703.2 on both jambs of the hoistway immediately below the floor...
-
Handrails [§405.8, §505]
The Standards do not require lower handrails serving children except at ramps serving play areas, but include a recommended height (28” max.) and separation (9” min.) from the required handrail...
-
M302.4.2 Clearance Around Base
The base of the diagnostic equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of...
-
M302.4.2 Clearance Around Base
The base of the equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the...
-
d. Unobstructed Transfer
does not appear to interfere with transferring onto and off of the shower seat.”...
-
11B-233.3.1.2.6.5 Additional requirements.
Water closet seat height complying with Section 11B-809.10.7.4. 7. Electrical receptacles, switches and controls complying with Section 11B-809.12. 8....
-
M302.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the seated position be usable with a patient lift and comply with either the proposed clearance in base (proposed...
-
ETA Opinion: ADA Signage at Exit Doors
men's and women's rooms, room numbers, exit signs [emphasis added]) must have raised and Brailled letters; must comply with finish and contrast standards; and must be mounted at a certain height...
-
Access Board: Standard Roll In Shower Stalls
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
Advocates for Access - Peoria Heights, IL
Location: Peoria Heights, IL. Advocates for Access is a private, not-for-profit, non-residential organization established in 1985....
-
1013.3 Height
1013.3 Height. Required guards shall not be less than 42 inches (1067 mm) high, measured vertically as follows: 1. From the adjacent walking surfaces; 2. ...
-
Adjustable height protocol
Percentage of subjects that were able to attain a transfer under adjustable height protocol Height (in) % Subjects Adjustable Height % Subjects Side...
-
Figure 608.5.2 Standard Roll-In Type Shower Compartment Control Location – Drawing from the U.S. Access Board
-
11B-221.2.1.6 Specialty seating areas
[ADA Title III] §36.308 Seating in assembly areas. ...
-
11B-221.2.1.6 Specialty seating areas
[ADA Title III] §36.308 Seating in assembly areas. ...
-
General Seating: ADA Standard Section 221.2.1.1
Section 221.2.1.1 covers scoping requirements in the current ADA Standards for general seating in assembly areas.
-
Ramps M303:3.3, 3.3.1, 3.3.2
As the height of the platform decreases, the length of the ramp can also decrease....
-
Priority 3: Toilet Rooms
Word Fillable Form (2.4MB) Word Non-Fillable Form (2.2MB) PDF Non-Fillable Form (0.7MB)
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
