Elements in compliance with an earlier standard issued pursuant to the Architectural Barriers Act or Section 504 of the Rehabilitation Act of 1973, as amended shall not be required to comply...
Search Results "Compliance"
-
How to Use This Pocket Guide
-
Poured in Place Rubber
However, a major concern was discovered at one of the test locations where the playground owner opted to also have the surface tested for impact attenuation and compliance with ASTM F1292...
-
Platform and Vehicle Floor Coordination: ADA Standard Section 810.5.3
Access Board’s Note to Reader: The Department of Transportation’s ADA standards note permitted alternatives where compliance is not operationally or structurally feasible in light rail...
-
1015.3 Height
ETA Editor's Note Sections from California Building Code Chapter 10 that are not adopted by the Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
11B-407.4.1 Car dimensions
Exception: In existing buildings, where existing shaft configuration prohibits strict compliance with Section 11B-407.4.1, existing elevator car configurations that provide a clear floor...
-
11B-407.4.1 Car dimensions
Exception: In existing buildings, where existing shaft configuration prohibits strict compliance with Section 11B-407.4.1, existing elevator car configurations that provide a clear floor...
-
1015.3 Height
ETA Editor's Note Sections from California Building Code Chapter 10 that are not adopted by the Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
Guardian Barrier-Free Eyewash: Deck Mounted, AutoFlow™ 90º Swing-Down GBF1849
ADA compliance is dependent on 27” knee clearance under counter and 34” maximum counter height. Spray heads swing down from storage to operational position, activating water flow....
-
Yale nexTouch™ Keypad Lock
to upgrade to ZigBee/Z-Wave or Data-on-Card technologies as system requirements change and grow Capacitive touchscreen or pushbutton keypad available, for tactile environments and ADA compliance...
-
Bradley Standard Series Vertical Recessed Soap Dispenser
Conformity and compliance to local and national codes is the responsibility of the installer....
-
Bradley Surface Mounted Tank-Type Vertical Valve Soap Dispenser 6562
Conformity and compliance to local and national codes is the responsibility of the installer....
-
Neo-Metro Commercial Contour Urinal 8944 Series
ADA compliance is subject to the interpretation and requirements of local code authority. Please check your local ADA regulations....
-
Bradley Surface Mounted, Horizontal Tank, Horizontal Valve Soap Dispenser 6542
Conformity and compliance to local and national codes is the responsibility of the installer....
-
Bradley Soap Dispenser With ABS Plastic Valve 6563
Conformity and compliance to local and national codes is the responsibility of the installer....
-
TownSteel TDC 85 ALUMINUM Grade 1 Door Closer
Maximum Door Opening Regular arm 180°， Parallel arm 180°， Top jamb 180° Finish Aluminum (AL) and Duro (DU) stock finishes, other upon request Warranty 25 years limited Code Compliance...
-
TownSteel ED1400F Grade 1 Mortise Fire Device
Specify handing when required Finish US32D, US10B stocked, other upon request Trim Available in 200 and 300 series, sold separately CODE COMPLIANCE ANSI/BHMA A156.3-2008 Grade...
-
Speedflow Hand Dryer
Protrudes less than 4 inches from the wall in compliance with ADA requirements High speed motor can be adjusted manually (by means of a potentiometer) to reduce noise levels...
-
Can parking signage height be considered a "safe harbor"?
Architectural and Transportation Barriers Compliance Board, July 1998 “Accessible spaces must be designated by the access symbol, which can be mounted on walls, posts, or from garage...
-
Braille Works
of your documents so you can meet WCAG and 508 compliance standards. ...
-
City of Plant City: ADA Coordinator
regarding accessibility compliance. ...
-
I. Need For and Final Objectives of the Guidelines.
Manufacturers may consider costs and available resources when determining whether and the extent to which compliance is required....
-
Vanity Counter Tops
In addition, the requirement for compliance with sections 308 and 309 has been removed in the final rule. This change is consistent with the ANSI A117.1 standard....
-
11B-707.4 Privacy
Justice considers the communication-related elements of ATMs to be auxiliary aids and services, rather than structural elements, to which the Safe Harbor allowance for elements built in compliance...
-
3. Modified Theaters
modifications listed here are minimum modifications mandated under this Consent Order and to the extent that actual modifications include and exceed those listed here, they will be deemed in compliance...
