I noticed that the specific code language suggests that the side grab bar and the rear grab bar must be at the same height (California CBC text is slightly different than ADAS), but it reads...
Search Results "Specification"
-
California: Toilet Grab Bars - Uneven height allowed?
-
Preserving elevator access in building where it might not be required.
Specifically, would the prohibition on reducing access (202.3.1) prohibit this, or is it OK because 206.2.3 would likely not require the elevator in the first place?...
-
Bus Stop Pads
Specifications in 810.2 for bus stops applied to "bus stop pads" in the proposed rule....
-
5.1 Overview of Legal Obligations
An employer may not make any pre-employment inquiries regarding disability, but may ask questions about the ability to perform specific job functions and may, with certain limitations, ask...
-
4. Enforcement and Remedies
An individual or a specific class of individuals or their representative alleging discrimination on the basis of disability by a state or local government may either file – (1) an administrative...
-
Rear Grab Bar
Some comments urged removal of the 24 inches specification. Response....
-
Elevator Car Controls
Specifically, the ANSI standard specifies a maximum reach height of 48 inches for forward or side reaches....
-
§ 382.7 General prohibition of discrimination
of any air transportation or related services that are available to other persons, even if there are separate or different services available for persons with a disability except when specifically...
-
Section 4.1.5, Additions (Preamble, Section-by-Section Analysis)
the addition is newly constructed each new space or element must comply with the applicable scoping provisions of sections 4.1.1 to 4.1.3 for new construction, the applicable technical specifications...
-
Shower Spray Unit
In addition, while the phrase "temperature limited" was not deemed necessary, the specification for water temperature has been revised to require that delivered water be 120 degrees maximum...
-
M305.2.6 Gripping Surfaces (Section-by-Section Analysis)
The proposed rule did not provide any specific requirements regarding gripping surfaces on transfer supports....
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
The proposed rule did not provide any specific restrictions regarding surface hazards around the transfer supports....
-
R304.5.1.2 Shared Use Paths
clarify that if flared sides are provided at curb ramps and blended transitions, the flared sides are to be located outside the width of the curb ramp run or blended transition; and a specific...
-
Scenario 7 – Reevaluations and FAPE
Although the Section 504 regulations do not set a specific timeframe within which students with disabilities must be reevaluated to make sure that they are receiving the appropriate services...
-
What is program accessibility?
beach Enjoying solitude in the wilderness Gathering information at a visitor’s center Learning about an area on an interpretive trail 7 CFR 15e provides specific...
-
Expert opinion on the current literature
External reviewers were sent a cover letter that described the purpose of the study and asked them to score each of the articles identified by the internal reviewers using a scoring sheet specifically...
-
Complaint Procedures
Carriers must develop a system for recording and collecting data regarding specific categories of written disability-related complaints that they receive according to the type of disability...
-
A. Accessibility of Terminal Facilities and Services
[Sec. 382.23(d)] As appropriate to your specific responsibilities and duties when dealing with the traveling public and consistent with all carriers’ obligation to ensure training to...
-
Training requirement. (Section-by-Section Analysis)
Some commenters proposed specific behavior or training standards for service animals, arguing that without such standards, the public has no way to differentiate between untrained pets and...
-
New Construction
These chapters provide design and technical specifications for elements, spaces, buildings, and facilities....
-
Using the Polling Place Checklist
Using the Polling Place Checklist Tools and Documentation A few simple tools may be used to measure the sizes and the slope of specific elements and spaces: • A metal tape measure...
-
7.1 Conditions for an Exception
Where one or more of the following conditions exists on a trail, an “exception” provided in the guidelines for that specific technical requirement can be used where that condition exists...
-
Trail Construction Techniques
Wetland Trail Design and Construction" is now located here: https://www.fhwa.dot.gov/environment/recreational_trails/publications/fs_publications/01232833/ Standard Forest Service trail specifications...
-
Technical Requirements for Accessible Hiker/Pedestrian Trails
In the spirit and intent of universal design, designers are encouraged to meet the highest standards wherever it is practicable, given the specific natural constraints of the environment...