If the ramp or landing has a vertical drop-off on either side of the ramp, is edge protection provided? [ADA Stds 4.8.7] Yes _____ No _____...
Search Results "Ramped Entry"
Commonly Searched Documents
-
4g.
-
4.7.7 Detectable Warnings
A curb ramp shall have a detectable warning complying with 4.29.2. The detectable warning shall extend the full width and depth of the curb ramp....
-
11B-406.6 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
d-vii
If the ramp or landing has a vertical drop-off on either side of the ramp, is edge protection provided? [ADA Standards § 4.8.7] Yes No...
-
407.2.3.1 Floor Designation
A tactile star shall be provided on both jambs at the main entry level....
-
608.2.2 Standard Roll-In Type Shower Compartments
30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides and shall have a 60 inches (1525 mm) wide minimum entry...
-
Getting In
Building entries must be flush with the grade of the outside access route and have a beveled doorsill that is not more than one-half inch high....
-
404.2.4 Maneuvering Clearances
EXCEPTION: Entry doors to hospital patient rooms shall not be required to provide the clearance beyond the latch side of the door....
-
11B-203.13 Raised boxing or wrestling rings
An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders or other means of reaching the raised elements...
-
FIGURE INDEX
Figure 406.3 Sides of Curb Ramps Figure 406.4 Landings at the Top of Curb Ramps Figure 406.6 Diagonal or Corner Type Curb Ramps Figure 406.7 Islands in Crossings Figure 406.8...
-
4. Assess During the Planning, Installation and Maintenance Phases
Begin at the entry to the play area. Identify the accessible play components and the path to entry/egress for each piece of accessible equipment. Then focus in on the accessible route....
-
406.7 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
1132A.4 Level floor or landing
Primary entry doors, required exit doors or secondary exterior doors with changes in height between the interior surface or floor level and the exterior surface or floor level shall comply...
-
608.2.3 Alternate Roll-In Type Shower Compartments
A 36 inch (915 mm) wide minimum entry shall be provided at one end of the long side of the compartment....
-
11B-608.2.3 Alternate roll-in type shower compartments
A 36 inch (914 mm) wide minimum entry shall be provided at one end of the long side of the compartment....
-
Comments
These commenters opposed any retrofit requirements, a few suggesting a that level-entry boarding requirement apply only to wholly new systems....
-
Comparison of Single-User Toilet Room Layouts: 2A, 2B, and 2C
Depending on the width of the hallway and other circulation issues, it can be preferable to swing the entry door into the toilet room....
-
P. MAINTENANCE OF ACCESSIBLE FEATURES AND TRAINING
Within nine (9) months of the entry of this Consent Decree, the County will submit for pre-approval by the United States a proposed training program, lasting at least four hours, on the...
-
P. MAINTENANCE OF ACCESSIBLE FEATURES AND TRAINING
Within nine (9) months of the entry of this Consent Decree, the County will submit for pre-approval by the United States a proposed training program, lasting at least four hours, on the...
-
1127B.5, Item 4
SECTION 1127B - EXTERIOR ROUTES OF TRAVEL 1127B.5 Curb ramps. 1. … 2. … 3. … 4. Level landing. ...
-
New Construction and Alterations
If you build a new facility or modify your existing one, (for example, work such as restriping the parking area, replacing the entry door or renovating the sales counter), make sure to consult...
-
10.3.1(7)*
of the general public, at least one accessible device for entering, and at least one for exiting, unless one device serves both functions, shall be provided at each accessible point of entry...
-
105.2.2 ASME
standard includes additional provisions for runway enclosures, electrical equipment and wiring, structural support, headroom clearance (which is 80 inches minimum), lower level access ramps...
-
105.2.2 ASME
standard includes additional provisions for runway enclosures, electrical equipment and wiring, structural support, headroom clearance (which is 80 inches minimum), lower level access ramps...