The control button for the emergency stop, alarm, door open, door close, main entry floor, and phone, shall be identified with raised symbols and Braille as shown in Table 11B-407.4.7.1.3...
Search Results "Input Floor"
Filters
Commonly Searched Documents
-
11B-407.4.7.1.3 Symbols
-
11B-809.8 Doors
The floor or landing at primary entry doors, required exit doors, and secondary exit doors where a change in elevation occurs between the interior and the exterior surface of the floor or...
-
11B-809.9.5 Lower shelving
Lower shelving and/or drawer space shall be provided at a height of 48 inches (1219 mm) maximum above the finish floor....
-
11B-809.10.8.3 Cabinets
The finished floor shall extend to the wall under the lavatory....
-
11B-409.3.2 Location
Elevator car doors or gates shall be positioned at the narrow end of the clear floor spaces required by Section 11B-409.4.1....
-
11B-708.4 Residential dwelling unit communication systems
Communications systems between a residential dwelling unit and a site, building, or floor entrance shall comply with Section 11B-708.4....
-
Vision Lights: ADA Standard Section 404.2.11
Section 404.2.11 covers the current ADA Standards for vision lights on manual doors and gates.
-
Seats: ADA Standard Section 604.4
Section 604.4 covers the current ADA Standards for the water closet seats.
-
Section 1193.35 Redundancy and Selectability [1193.33 in the NPRM] (Section-by-Section Analysis)
Section 1193.35 Redundancy and Selectability [1193.33 in the NPRM] (Section-by-Section Analysis) This section proposed that products incorporate multiple modes for input and output functions...
-
Introduction
Gathering Input from Customers with Disabilities (http://www.ada.gov/custinfo.pdf) For these meetings to be successful, everyone involved must have an equal opportunity to participate...
-
G. Other types of equipment and furniture
The Department welcomes public input on other types of equipment and furniture that warrant attention....
-
FAQ: Why should I enter ADA references in my Voices post?
Read FAQ: How do I input ADA references in my Voices post?...
-
2.4.3 Impetus for Manufacturers to Improve MDE Accessibility
Their design processes are centered around delivering high quality medical devices based on advice primarily from medical professionals, although some manufacturers occasionally seek input...
-
3. Comparison of WCAG 2.0 to Existing 508 Standards
Keyboard operability is also essential for many individuals with motor impairments who use alternate keyboards, or input devices that act as keyboard emulators when accessing ICT because...
-
M301.4.1 Clearance in Base (Section-by-Section Analysis)
The Access Board sought input in question 25 in the MDE NPRM preamble, on whether the proposed dimensions for the clearance in base requirement is sufficient to allow for the use of portable...
-
Leveling: ADA Standard Section 409.4.4
Section 409.4.4 covers the ADA Standards for the self-leveling feature in private residence elevators.
-
Buttons: ADA Standard Section 407.4.6.2
Section 407.4.6.2 covers the current ADA Standards for the elevator car control buttons.
-
Height: ADA Standard Section 902.4.2
The tops of tables and counters shall be 26 inches (660 mm) minimum and 30 inches (760 mm) maximum above the finish floor or ground....
-
Visibility: ADA Standard Section 707.7.1
The display screen shall be visible from a point located 40 inches (1015 mm) above the center of the clear floor space in front of the machine....
-
Tray Slides: ADA Standard Section 904.5.2
The tops of tray slides shall be 28 inches (710 mm) minimum and 34 inches (865 mm) maximum above the finish floor or ground....
-
412.2.6 Accessibility
[DSA-AC] In air traffic control towers, an accessible route shall not be required to serve the cab and the equipment areas on the floor immediately below the cab....
-
11B-707.7.1 Visibility
The display screen shall be visible from a point located 40 inches (1016 mm) above the center of the clear floor space in front of the machine....
-
11B-409.4.4 Leveling
Each car shall automatically stop at a floor landing within a tolerance of ½ inch (12.7 mm) under rated loading to zero loading conditions....
-
11B-904.5.2 Tray slides
The tops of tray slides shall be 28 inches (711 mm) minimum and 34 inches (864 mm) maximum above the finish floor or ground....