Where passenger loading zones are provided, the 1991 Standards, at sections 4.1.2(5) and 4.6.6, require at least one passenger loading zone to be accessible....
Search Results "Industry Standard"
Filters
Commonly Searched Documents
-
Passenger Loading Zones
-
General
Where parking spaces are provided, the 1991 Standards, at sections 4.1.2 (5)(a) and (7) and 7(a), and the 2010 Standards, at section 208.1, require a specified number of the parking spaces...
-
205 and 309 Operable Parts
205 and 309 Operable Parts Section 4.1.3, and more specifically sections 4.1.3(13), 4.27.3, and 4.27.4 of the 1991 Standards, require operable parts on accessible elements, along accessible...
-
Use of Mandatory Language in Proposed Guidelines
proposed guidelines use the mandatory language “shall” and “requirement” because the guidelines are intended to be adopted, with or without additions and modifications, as accessibility standards...
-
Use of the ISA Under the ADA
The ADA Standards apply nationwide to places of public accommodation, commercial facilities, and state and local government facilities....
-
ENDNOTES
iv The Access Board, ADAAG Standards, www.accessboard.gov/adaag v Handinet, www.handinet.org/adaag.htm#4.3 (Accessible Route) The Access Board, ADAAG Standards....
-
11B-201.1 Scope
[ADA Title III] §36.406(b) Standards for New Construction and Alterations; Scope of Coverage....
-
a. The employer's judgment
the quality or quantity of work that must be performed by a person holding a job, or be required to set lower standards for the job....
-
M101.1 Purpose (Section-by-Section Analysis)
The MDE NPRM proposed that the purpose of the MDE Standards was to establish technical criteria for diagnostic equipment that is accessible to and usable by patients with disabilities and...
-
Restrooms Main Lobby
See Standards § 4.13.6. l....
-
7. APPLICABILITY
These new DoD Standards are effective immediately....
-
11B-201.1 Scope
[ADA Title III] §36.406(b) Standards for New Construction and Alterations; Scope of Coverage....
-
INTRODUCTION
These changes include revised accessibility standards, called the 2010 Standards for Accessible Design (2010 Standards), which establish minimum criteria for accessibility in design and...
-
Executive Summary
Small entities comprise the vast majority of firms in this industry. ...
-
11B-202.3.1 Prohibited reduction in access
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
Multiple Single-User Toilet Rooms
Where multiple single-user toilet rooms are clustered in a single location, fifty percent (50%), rather than the one hundred percent (100%) required by the 1991 Standards, are required to...
-
5.2.2.1 Transfer Surface Width Recommendations for M302
recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily used by patients in a seated position as described in its proposed standard...
-
B.3.iv - Who makes the determination that a product meets equivalent facilitation?
The vendor may assert that its product meets or exceeds the level of accessibility required by a particular standard through equivalent facilitation....
-
24.1 Q. What types of grab bars should the reinforcement be designed to accommodate and what types may be used if the builder elects to install grab bars in some units at the time of construction?
In determining what is an appropriate grab bar, builders are encouraged to look to the 1986 ANSI A117.1 standard, the standard cited in the Fair Housing Act....
-
§ 36.304(d)(2)(iii)
., elements for which there are neither technical nor scoping specifications in the 1991 Standards), and therefore those elements must be modified to the extent readily achievable to comply...
-
Alterations and Additions
This guide provides an introduction to the scoping requirements that form the basis for the Department of Justice’s 2010 ADA Standards and the Department of Transportation's ADA Standards...
-
11B-202.3.1 Prohibited reduction in access
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
2. Public Comments on the Initial Regulatory Assessment and Department Responses
The Department received 436 comments during the 2014 NPRM comment period from a variety of stakeholders, including movie industry representatives, individuals with disabilities, advocacy...
-
E202.7 Best Meets
Where ICT conforming to one or more requirements in the Revised 508 Standards is not commercially available, the agency shall procure the ICT that best meets the Revised 508 Standards consistent...