(i) Newly constructed or altered facilities or elements covered by §§35.151(a) or (b) that were constructed or altered before March 15, 2012, and that do not comply with the 1991 Standards...
Search Results "Industry Standard"
-
§ 35.151(c)(5)(i)
-
Comparison of Single-User Toilet Room Layouts: 2A, 2B, and 2C
Comparison of Single-User Toilet Room Layouts: 2A, 2B, and 2C 1991 Standards Plan-2A: 1991 Standards Minimum with In-Swinging Door 5’-0" x 8’-6" • 42.50...
-
Executive Summary
The U.S. standards are based on research completed in the late 1970’s....
-
B. Patient Protection and Affordable Care Act and Section 510 of the Rehabilitation Act
Accordingly, the statutory deadline for issuing the standards is March 23, 2012....
-
Mono Jacks, Sound Pressure, Etc
Section 4.33.7 of the 1991 Standards does not contain specific technical requirements for assistive listening systems....
-
Frequently Asked Questions about Play Areas
Frequently Asked Questions about Play Areas This document answers frequently asked questions concerning requirements for accessible play areas in standards issued under the Americans...
-
C102.1 Incorporation by Reference
Where conflicts occur between the 255 Guidelines and the referenced standards, these guidelines apply....
-
§ 35.151(c)(2)
alterations commence on or after September 15, 2010 and before March 15, 2012, then new construction and alterations subject to this section may comply with one of the following: The 2010 Standards...
-
Aisle Stairs and Ramps in Assembly Areas
access must comply with the technical requirements for stairs set out in section 4.9 of the 1991 Standards....
-
11B-809.5.2 Residential dwelling unit smoke detection system and carbon monoxide detection system
[2010 ADA Standards] 809.5.2 Residential Dwelling Unit Smoke Detection System....
-
11B-505.10.3 Bottom extension at stairs
[2010 ADA Standards] 505.10.3 Bottom Extension at Stairs....
-
11B-809.5.2 Residential dwelling unit smoke detection system and carbon monoxide detection system
[2010 ADA Standards] 809.5.2 Residential Dwelling Unit Smoke Detection System....
-
11B-505.10.3 Bottom extension at stairs
[2010 ADA Standards] 505.10.3 Bottom Extension at Stairs....
-
T102.3 Vehicle Length
The length of non-rail vehicles shall be measured from standard bumper to standard bumper....
-
§100.201a(a)
(a) The following standards are incorporated by reference into 24 CFR part 100 pursuant to 5 U.S.C. 552(a) and 1 CFR part 51, as though set forth in full....
-
BTX Intelligent Fashion Motorized Roller Shades
The BTX Intelligent Fashion Roller Shade program combines some of the most advanced motorization technology in the industry with a broad collection of designer textiles for both contemporary...
-
Use Zone
The ground level area beneath and immediately adjacent to a play structure or play equipment that is designated by ASTM F 1487 (incorporated by reference, see “Referenced Standards” in Chapter...
-
11B-407.4.7.1.2 Location
[2010 ADA Standards] EXCEPTION: Where space on an existing car operating panel precludes tactile markings to the left of the controls, markings shall be placed as near to the control...
-
11B-407.4.7.1.2 Location
[2010 ADA Standards] EXCEPTION: Where space on an existing car operating panel precludes tactile markings to the left of the controls, markings shall be placed as near to the control...
-
Declaration of Conformity
A few commenters from the telecommunications industry and disability organizations urged the Board to adopt the Declaration of Conformity as recommended by the TAAC....
-
Operable Parts of Windows
Comment from industry opposed such a requirement....
-
Automated Revolving Doors
While manufacturers have developed safety criteria, the industry safety code for automated doors referenced by ADAAG does not currently address revolving doors, and certain questions remain...
-
2.1.3. Baseline
The baseline represents the Department’s best assessment of the state of the movie exhibition industry. ...
