Ramp runs with a rise greater than 6 inches (150 mm) shall have handrails complying with 505. Exceptions: Reserved. Reserved. Curb ramps do not require handrails....
Search Results "Curb Ramp Width"
Filters
Commonly Searched Documents
-
11B-405.8 Handrails
-
13 [§ 4.7.10]
13 [§ 4.7.10] A corner-type curb ramp is located at the center (or apex) of a corner and is often aligned to direct users into the middle of an intersection....
-
406.1 General
Curb ramps on accessible routes shall comply with 406, 405.2 through 405.5, and 405.10....
-
406.1 General
Curb ramps on accessible routes shall comply with 406, 405.2 through 405.5, and 405.10....
-
Clear Width: ADA Standard Section 404.3.1
Section 404.3.1 covers the current ADA Standards for clear width at automatic and power-assisted doors and gates.
-
406.1 General
Curb ramps on accessible routes shall comply with 406, 405.2 through 405.5, and 405.10....
-
City of Bend Oregon Curb Ramp Commitment
Requires the Registered User plan or above. Login! -
Sides of Curb Ramps: ADA Standard Section 406.3
Section 406.3 covers the current ADA Standards for curb ramp flares.
-
R304.1 General
There are two types of curb ramps: • Perpendicular curb ramps have a running slope that cuts through or is built up to the curb at right angles or meets the gutter break at right angles...
-
Built-Up Curb Ramps
A top landing at least 36” deep is required at all built-up curb ramps....
-
Is there a maximum distance between ramp handrails?
The Standards do not require center or intermediate handrails on wide ramps....
-
Issue: Curb Ramps
Curb ramps provide basic access at intersections and pedestrian crossings....
-
11 [§ 4.7.6]
11 [§ 4.7.6] A built-up curb ramp typically consists of asphalt or concrete that is poured and shaped into a ramp that runs at a 90-degree angle away from an intact curb down to the roadway...
-
8 [§§ 4.3.3; 4.3.7]
8 [§§ 4.3.3; 4.3.7] Curb ramps should have at least 36 inches of clear space at the “top” of the ramp, which can be seen in the illustration to the right [below]....
-
E. What are the General Requirements for Curb Ramps in the ADA Standards for Accessible Design?
(On a curb ramp, the running slope is the slope in the direction of pedestrian travel on the ramp run.) [§ 4.8.2] For curb ramps constructed after January 26, 1992 (post-ADA...
-
11B-406.5.7 Cross slope
The cross slope of curb ramps and blended transitions shall be 1:48 maximum....
-
Clear Width [§405.5]
Clear Width [§405.5] Ramp runs must have a clear width of 36” minimum (measured between handrails where provided)....
-
11B-406.5.4 Floor or ground surfaces
Floor or ground surfaces of curb ramps and blended transitions shall comply with Section 11B-405.4....
-
H. How Can You Tell if a Curb Ramp is Accessible?
The best way to determine if a curb ramp is accessible is to survey it to determine the extent to which it complies with ADA accessibility requirements....
-
11B-406 CURB RAMPS, BLENDED TRANSITIONS AND ISLANDS
11B-406 Curb ramps, blended transitions and islands [2010 ADAS] 406 Curb Ramps ETA Editor's Note The differences between 2010 ADAS Section 406 and 2013 CBC Section 11B-406...
-
7. Exterior Ramp Running Slope
7. ...do the exterior ramps have running slopes of 1:12 or less (critical dimension of 2" or less)?...
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....