Section 206.2.5 covers scoping requirements in the most current ADA Standards for accessible routes in restaurants and cafeterias
Search Results "AHJ: Authority Having Jurisdiction"
Commonly Searched Documents
-
Restaurants and Cafeterias: ADA Standard Section 206.2.5
-
11B-206.3 Location
devices, fare vending or other ticketing areas, and fare collection areas shall be placed to minimize the distance which wheelchair users and other persons who cannot negotiate steps may have...
-
1010.2.13.1 Delayed egress locking system
Once the delay electronics have been deactivated, rearming the delay electronics shall be by manual means only....
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
- Pilot Rock Sign Benches
-
§ 36.403(h)(1)
obligation to provide an accessible path of travel may not be evaded by performing a series of small alterations to the area served by a single path of travel if those alterations could have...
-
4.8.5* Handrails
If a ramp run has a rise greater than 6 in (150 mm) or a horizontal projection greater than 72 in (1830 mm), then it shall have handrails on both sides....
-
4.5.4 Gratings
If gratings are located in walking surfaces, then they shall have spaces no greater than 1/2 in (13 mm) wide in one direction (see Fig. 8(g))....
-
4.5.4 GRATINGS
If gratings are located in walking surfaces, then they shall have spaces no greater than 1/2 in (13 mm) wide in one direction (see Fig. 8(g))....
-
§ 38.95(c)(2) Ramp surface
The ramp or bridge plate surface shall be continuous and slip resistant, shall not have protrusions from the surface greater than 1/4 inch high, shall have a clear width of 30 inches and...
-
§ 38.125(c)(2) Ramp surface
The ramp or bridge plate surface shall be continuous and slip resistant, shall not have protrusions from the surface greater than 1/4 inch high, shall have a clear width of 30 inches and...
-
M307.2 Tactilely Discernible (Section-by-Section Analysis)
Patients who are blind or have low vision have difficulty distinguishing a flat membrane button or similar control unless it is tactilely discernible from the surrounding surface and any...
-
406.6 Diagonal Curb Ramps
Diagonal or corner type curb ramps with returned curbs or other well-defined edges shall have the edges parallel to the direction of pedestrian flow....
-
11B-411.2.1.2.1 Keypads
The number five key shall have a single raised dot....
-
Why You Should Carry Emergency Health Information
The care you receive in emergency situations depends on how much information physicians have at the time of the emergency....
-
11B-411.2.1.2.1 Keypads
The number five key shall have a single raised dot....
-
11B-411.2.1.2.1 Keypads
The number five key shall have a single raised dot....
-
Finish and Contrast: ADA Standard Section 703.6.2
Pictograms and their field shall have a non-glare finish....
-
General: ADA Standard Section 707.1
If farecards have one tactually distinctive corner they can be inserted with greater accuracy....
-
Sloped Entries: ADA Standard Section 1009.3
Some may have batteries, motors, and electrical systems that when submerged in water may cause damage to the personal mobility device or wheelchair or may contaminate the pool water....
-
11B-407.4.7.2 Keypads
The number five key shall have a single raised dot. The dot shall be 0.118 inch (3 mm) to 0.120 inch (3.05 mm) base diameter and in other aspects comply with Table 11B-703.3.1....
-
11B-602.2 Clear floor space
Units shall have a clear floor or ground space complying with Section 11B-305 positioned for a forward approach and centered on the unit....
-
11B-213.2.1 Unisex (single-user or family) toilet and unisex (single-user or family) bathing rooms
Doors to unisex (single-user or family) toilet rooms and unisex bathing rooms shall have privacy latches....
- Kompan, Inc. Electronic Playgrounds - ICON1014 - Swirl