Within play areas, protruding objects on circulation paths shall not be required to comply with 307 provided that ground level accessible routes provide vertical clearance in compliance...
Search Results "Vertical Actuation Bar"
-
204.1 General
-
8. Service Animals
.: restaurants, bar areas, facility grounds, vans/shuttle buses, and other areas for meeting or recreation)?...
-
D3. Door Hardware
., lever, pull, panic bar) usable with one hand without tight grasping, pinching, or twisting of the wrist?...
-
Controls [4.21.5]
Grab bars are configured differently in showers with seats so that a person can lean back against the wall for support....
-
11B-604.7.2 Disposal units
The disposal unit shall be located below the grab bar, with the opening of the disposal unit 19” minimum (483 mm) above the finish floor....
- DORMA 8000 Series Exit Device
-
1009.7.2 Separation
The fire-resistance-rated construction shall extend vertically from the ground to a point 10 feet (3048 mm) above the floor level of the area for assisted rescue or to the roof line, whichever...
-
1009.7.2 Separation
The fire-resistance-rated construction shall extend vertically from the ground to a point not less than 10 feet (3048 mm) above the floor level of the area for assisted rescue or to the...
-
11B-221.6 Semi-ambulant seats
following criteria — i) It is located within the rear 60% of the seats provided in an auditorium; or i) It is located within the area of an auditorium in which the vertical...
-
11B-221.6 Semi-ambulant seats
following criteria — i) It is located within the rear 60% of the seats provided in an auditorium; or i) It is located within the area of an auditorium in which the vertical...
-
Birthing Room Bath Tub Accessibility
fully accessible toilet rooms and showers Both rooms equipped with a bath tub - used to "ease discomfort" during labor Question are bath tubs required to be fully accessible (grab bars...
- Bradley 1-Stall Seat Cover/Tissue Dispenser 5922
- Wikk Industries Inc. Push Plate 6 Inch ROUND SWITCHES
- Wikk Industries Inc. Push Plate PART# BPS SM PRP36 CL (628)
- Wikk Industries Inc. Push Plate 4 1/2 Inch ROUND SWITCHES
-
11B-704.5 TTY shelf
The shelf shall be capable of accommodating a TTY and shall have 6 inches (152 mm) minimum vertical clearance above the area where the TTY is to be placed....
-
704.5 TTY Shelf
The shelf shall be capable of accommodating a TTY and shall have 6 inches (150 mm) minimum vertical clearance above the area where the TTY is to be placed....
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
R308.1.2.1 Platform and Vehicle Floor Coordination
The Department of Transportation regulations (49 CFR parts 37 and 38) require the height of the vehicle floor and the station platform to be coordinated so as to minimize the vertical and...
-
4.31.9(2)
The shelf shall be capable of accommodating a text telephone and shall have 6 in (152 mm) minimum vertical clearance in the area where the text telephone is to be placed....
-
Cross Slope
This may be expressed as the percentage of change in elevation or as a ratio of vertical distance to horizontal distance....
-
4.34.3(2)(a) Reach Depth Not More Than 10 in
Where the reach depth to the operable parts of all controls as measured from the vertical plane perpendicular to the edge of the unobstructed clear floor space at the farthest protrusion...
-
§ 38.95(b)(7) Platform gaps
car floor height with the inner barrier down (if applicable) or retracted, gaps between the forward lift platform edge and car floor shall not exceed 1/2 inch horizontally and 5/8 inch vertically...
-
§ 38.125(b)(7) Platform gaps
car floor height with the inner barrier (if applicable) down or retracted, gaps between the forward lift platform edge and car floor shall not exceed 1/2 inch horizontally and 5/8 inch vertically...