However, if a condition for exception in an alteration project at an existing site prohibits full compliance with a specific requirement for clear floor or ground space (surface, slope,...
Search Results "Horizontal Projection"
-
Trash, Recycling, and Other Essential Containers
-
Clear Tread Width and Passing Spaces for Outdoor Recreation Access Routes
To determine how wide the outdoor recreation access routes in a project should be, look at the level of development of the site and how the site will be used....
-
VII. APPENDIX: OTHER SOURCES OF INFORMATION
ADA publications and questions 800-949-4232 (voice/TTY) Internet address www.adata.org Project ACTION is funded by the U.S....
-
III-6.1000 General
Because the restriping may affect the ability of individuals with disabilities to gain access to the facility, the restriping project would be considered an alteration and therefore must...
-
7.1. Purpose and Objective of the Final Rule, Relative to Movie Theaters Categorized As Small
Recent technological changes in the movie exhibition industry—including widespread conversion from analog film projection to digital cinema systems—make exhibition of captioned and audio-described...
-
Conference Papers and Journals
Conference Papers and Journals From the initial stages of the project, when it was funded by NIDRR, the research staff submitted and presented papers and presentations to annual and other...
-
11B-805.6 Hand washing fixtures, lavatories and sinks
The implications of this interpretation are that a wall-mounted china fixture of the most common size, nominally 20 inches wide x 18 inch projection, cannot serve as a handwashing fixture...
-
11B-805.6 Hand washing fixtures, lavatories and sinks
The implications of this interpretation are that a wall-mounted china fixture of the most common size, nominally 20 inches wide x 18 inch projection, cannot serve as a handwashing fixture...
-
Conditions for Exceptions [1019]
Prevailing construction practices are those used by most contractors or designers faced with the same or similar projects in the area....
-
FIGURE INDEX
Space Access Aisle Figure 503.3 Passenger Loading Zone Access Aisle Figure 504.5 Stair Nosings Figure 505.4 Handrail Height Figure 505.5 Handrail Clearance Figure 505.6 Horizontal...
-
Section 35.151(g)(4)
The vertical viewing angle is the angle between a horizontal line perpendicular to the seated viewer’s eye to the screen and a line from the seated viewer’s eye to the top of the screen....
-
Section 36.406(f)(4)
The vertical viewing angle is the angle between a horizontal line perpendicular to the seated viewer’s eye to the screen and a line from the seated viewer’s eye to the top of the screen....
-
1118B.4
Changes in level between 1/4 inch (6.4 mm) and 1/2 inch (12.7 mm) shall be beveled with a slope no greater than one unit vertical in 2 units horizontal (50-percent slope) [see Figure 11B...
-
M305.2.3 Height (Section-by-Section Analysis)
The transfer support is permitted to be horizontal, angled, curved, or a combination of these as long as the top of any point along the gripping surface is located at or between 6 inches...
-
5.4.1.2 Transfer and Positioning Support Location Recommendations for Imaging Equipment with Transfer Surfaces
For example, some x-ray tables require bi-directional horizontal movement to perform the functions for the images. A new generation of equipment is necessary to address this....
-
3.3.2 Experienced Clinicians
These deliberations will include discussions about the position (horizontal, angled, or vertical), length, gripping shape, and distance above and from the transfer surface....
-
7.2 Technological and Scientific Considerations
For instance, some x-ray tables require bi-directional horizontal movement to generate the specific image required for diagnostic purposes....
-
Guest Bathrooms
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds is applied at any point on the grab bar, fastener, mounting device, or supporting...
-
Station 5-Lateral Operating Space (Sweep Width)
Accordingly, researchers focused the survey design, hence data collection, of space dimensions to actual occupied horizontal and vertical dimensions of users operating within uncrowded pathway...
-
Institute for Design and Disability (IDD) (Ireland)
There is also information on the projects which IDD has carried out, the awards achieved and details of the political campaigns being pursued in the interest of defending the right of people...
-
Construction Specifications Institute (CSI)
Education and certification of professionals to improve project delivery processes. Creation of practice tools to assist users throughout the facility life-cycle. ...
-
Rehabilitation Engineering Research Center on Accessible Public Transportation
Industry partners in this project include Gillig Corporation, Tiramisu Transit, LLC, NFTA, and LINC-Design, LLC....
