(a) A clear floor space at least 30 inches by 48 inches that allows a parallel approach by a person in a wheelchair is provided at the range or cooktop and sink, and either a parallel or...
Search Results "Floor Destination Indicator"
-
7(1)(a)
-
1133A.1 General
) (1) 30" minimum countertop space for sink installation with removable base cabinet and finish flooring beneath the sink; 30" x 48" minimum clear floor space to allow parallel...
-
Slope Meters and Levels
Corada has reviewed several models of slope meters and levels to assist accessibility surveyors in measuring slope and level changes. The following are the models that can be...
- Access Board: Toilet Rooms
-
1150A.1 General
Sites where either Test No. 1 or Test No. 3 is used and it is determined that an accessible route to the common (lobby) entrance is not required, at least 20 percent of the ground floor...
-
Confirm that the vibrotactile indications work
Confirm that the vibrotactile indications work The tactile arrow or vibrating surface should vibrate rapidly only during the walk interval for the street....
-
Conclusion
study found that the majority of participants (5th percentile) could transfer independently to the platform at a height that was within one inch of the mean wheelchair or scooter seat to floor...
-
11B-233.3.1.2.6 Public housing facility site impracticality
The site impracticality tests in this section may be used to determine the number of required residential dwelling units with adaptable features in buildings without an elevator,...
-
11B-233.3.1.2.6 Public housing facility site impracticality
The site impracticality tests in this section may be used to determine the number of required residential dwelling units with adaptable features in buildings without an elevator,...
-
7(2)(b)(v)
The top of the fixture rim is a maximum height of 2'10" above the finished floor. If kneespace is provided below the vanity, the bottom of the apron is at least 2'3" above the floor....
-
1010.1.4 Floor elevation
There shall be a floor or landing on each side of a door. Such floor or landing shall be at the same elevation on each side of the door....
-
1010.1.4 Floor elevation
There shall be a floor or landing on each side of a door. Such floor or landing shall be at the same elevation on each side of the door....
- Figure 1007.3.2 Golf Club Reach Range Area – Drawing from the U.S. Access Board
-
Rough Form and Foundation Inspection
ensure correct accessible slopes (5% running slope and 2.08% cross slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor...
-
Rough Form and Foundation Inspection
ensure correct accessible slopes (5% running slope and 2.08% cross slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor...
-
Guest Rooms
Bed heights for accessible rooms should be between 17-23 inches above the floor Do not have border frame which prevents the wheelchair from being directly next to the mattress....
-
Technical Memorandum TM 2013-14 Dining Surfaces
Length Clear floor space complying with TAS 305 for a forward approach is required for an accessible dining surface based on TAS 902.2....
- Landscape Forms Inc. Select Modular Steel Recycling Units
- Magnuson Group UMEA Waste Receptacles
-
407.2.1.4 Location
EXCEPTION: Destination-oriented elevators shall not be required to comply with 407.2.1.4. Advisory 407.2.1.4 Location, Exception....
-
407.2.1.4 Location
EXCEPTION: Destination-oriented elevators shall not be required to comply with 407.2.1.4. Advisory 407.2.1.4 Location Exception....
-
407.2.1.4 Location
EXCEPTION: Destination-oriented elevators shall not be required to comply with 407.2.1.4. Advisory 407.2.1.4 Location Exception....
-
General description of monetized benefits for water closet clearance in single-user toilet rooms—out-swinging doors (Req. #28)
In order to assess monetized benefits for the requirement covering water closet clearances in single-user toilet rooms with out-swinging doors, a determination needed to be made...
-
3.4.6 Surface
The surface of each viewing area shall be firm and stable. The type of surface should be appropriate to the setting and level of development.