Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
Search Results "Built-In Seating"
Filters
Commonly Searched Documents
-
Structural Strength: ADA Standard Section 903.6
-
106.5 Defined Terms, F106.5 Defined Terms
The definition lists travel trailers, park models, manufactured housing, and other factory built housing among the structures covered by the definition....
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests. ...
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests....
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests....
-
Ticketing (Assembly areas, not parking.)
People purchasing a ticket for an accessible seat may purchase up to three additional seats for their companions in the same row and these seats must be contiguous with the accessible seat...
-
Sec.36.607(a)(2)
For example, if certain equipment is not covered by the code, the determination of equivalency cannot be used as evidence with respect to the question of whether equipment in a building built...
-
Work Area Equipment
As used in this document, this term shall apply only to equipment that is permanently installed or built-in in employee work areas....
-
New Construction and Alterations
New Construction and Alterations Businesses whose facilities were built or altered since the ADA went into effect must comply with the ADA Standards for Accessible Design so that the...
-
10. Vertical Clearance at Exterior Stairs
10. ...are all exterior stairs built so blind persons and persons with low vision will not hit their head(s) on the underside (i.e.: protected with a cane detectable warning, such as the...
-
M14
Is the operating control (switch, lever, button, or pull) for each type of dispenser or built-in equipment no higher than 54 inches above the floor (if there is clear floor space for a parallel...
-
4.15.5(2)
(2) Free-standing or built-in units not having a clear space under them shall have a clear floor space at least 30 in by 48 in (760 mm by 1220 mm) that allows a person in a wheelchair to...
-
4.15.5(2)
(2) Free standing or built-in units not having a clear space under them shall have a clear floor space at least 30 in by 48 in (760 mm by 1220 mm) that allows a person in a wheelchair to...
-
Pilot Rock UT Series Side Accessible Picnic Table Using Recycled Plastic
Built rugged, but with less weight, easier to move. A section of seating is removed from the side(s) for ADA COMPLIANT wheelchair accessibility right in the middle of activities. ...
-
11B-306.3.3 Minimum required depth
the finish floor or ground at a depth of 8 inches (203 mm) minimum increasing to 29 inches (737 mm) high minimum above the finish floor or ground at the front edge of a counter with a built-in...
-
10) Assembly areas
10) Assembly areas ADAAG: * Wheelchair seating: Requirements triggered in any assembly area with fixed seating that seats four or more people....
-
221 Assembly Areas
seating (221.5)....
-
A4.33.3 Placement of Wheelchair Locations
Building/life safety codes set minimum distances between rows of fixed seats with consideration of the number of seats in a row, the exit aisle width and arrangement, and the location of...
-
Pilot Rock UT Series Side Accessible Picnic Table Using Aluminum
Built rugged, but with less weight, easier to move. A section of seating is removed from the side(s) for ADA COMPLIANT wheelchair accessibility right in the middle of activities. ...
-
Pilot Rock WUT and WUTH Picnic Table - Using Aluminum
They are built rugged, but with less weight and easier to move. Now, EVERY picnic table in your facility can be fully accessible!...
-
Wheelchair Storage Space: ADA Standard Section 1002.5.4
Wheelchair storage spaces complying with 305 shall be provided in or adjacent to unload areas for each required amusement ride seat designed for transfer and shall not overlap any required...
-
Background
The built environment can either increase or decrease the effort required to perform independent transfers [6]. ...
-
221.2.3.2 Vertical Dispersion
or other movable structures in an area where fixed seating is not provided, in order to increase seating for an event, wheelchair spaces and companion seats may be placed in that section...
-
Ticket Transfers and Secondary Ticket Market
Venues cannot require that accessible seats only be transferred to someone with a disability....
