vehicles shall be coordinated with the boarding platform design such that the horizontal gap between each vehicle door at rest and the platform shall be no greater than 3 inches and the height...
Search Results "Counter Height"
Filters
Commonly Searched Documents
-
§ 38.53(d)(1) Requirements
-
4.2 Stretchers
As currently designed, oxygen cylinders are typically transported in a horizontal position below the patient bed surface, consuming critical vertical height....
-
Addition
An expansion, extension, or increase in the gross floor area or height of a building or facility....
-
106.5.3 Addition
An expansion, extension, or increase in the gross floor area or height of a building or facility....
-
Thresholds at Doorways [4.13.8]
ADAAG specifies a maximum threshold height of ½ inch, but allows a height up to ¾ inch at exterior sliding doors where necessary to prevent water damage....
-
[A] 101.2 Scope
Exception: Detached one- and two-family dwellings and multiple single-family dwellings (townhouses) not more than three stories above grade plane in height with a separate means of egress...
-
101.2 Scope
Exception: Detached one- and two-family dwellings and townhouses not more than three stories above grade plane in height with a separate means of egress, and their accessory structures...
-
11B-604.5 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped grab bar meeting the dimensional requirements of Sections 11B-604.5.1 and 11B-604.5.2 shall...
-
Sample Size Estimation
Data from the maximum and minimum height transfers from protocol A were used for this analysis....
-
Plan 6A: 12-Foot Wide Accessible Guest Room
The following accessible features are provided in the bathroom: • Comparable vanity counter top space (section 806); • Transfer shower (section 603.2); • Shower seat (section 610.3...
-
Plan 3B: 12-Foot Wide Accessible Guest Room
The following accessible features are provided in the bathroom: • Comparable vanity counter top space (section 806); • Standard roll-in type shower with folding seat (section 608.2.2...
-
Mammography Equipment
The mammography machine will need to adjust to their height and accommodate the space of the wheelchair....
-
Handrails [4.8.5]
The height of a guardrail (to prevent falling off the edge) is not specified by ADAAG; local building codes do, however, commonly regulate the minimum height of a guardrail at 42 inches....
-
Addition
An expansion, extension, or increase in the gross floor area or height of a building or facility....
-
Table 1
the requirements in the DOJ 2010 Standards because the requirements are the same. 24The requirements analyzed in Table 1 include: drinking fountains, public toilet facilities, tables, counters...
-
Notes
Seat heights for males were typically higher than for females....
-
SUMMARY OF THE 19-INCH RECOMMENDATION
Access Board’s Medical Diagnostic Equipment Technical Advisory Committee discussed transfer surface height extensively....
-
Just Manufacturing Classroom Concealed Ledgemount Teardrop Handle Faucet
Classroom faucets feature rigid spouts, or restricted swing spouts, providing preventative measures against wet counter tops in the classroom....
-
Just Manufacturing Concealed Classroom Faucet with Triple Radius Spout
Classroom faucets feature rigid spouts, or restricted swing spouts, providing preventative measures against wet counter tops in the classroom....
-
SafePath: Threshold Ramp Installation for MultiFamily Housing for Disability Access
One of the largest violations of Fair Housing Act (FHA) regulations is the treatment or perceived compliance specific to threshold heights. ...
-
11B-703.2.6 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character....
-
1132A.4.1, Item 1
Thresholds with a change in height of not more than ¼ inch (6.35 mm) may be vertical....
-
703.2.6 Stroke Thickness
Stroke thickness of the uppercase letter "I" shall be 15 percent maximum of the height of the character....
-
703.2.6 Stroke Thickness
Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character....
