Transfer Steps The maximum height of transfer steps is 8 inches, although shorter heights are recommended....
Search Results "Counter Height"
Filters
Commonly Searched Documents
-
Transfer Steps
-
Urinal Flush Controls
The proposed rule specified a maximum height of 44 inches (the maximum height for obstructed forward reaches)....
-
Entry Points and Seats
When play components are located on an accessible route, the height required to transfer directly to the entry point or seat of a play component has a minimum of 11 inches (280 mm) and a...
-
704.11.1 Parapet construction
The height of the parapet shall not be less than 30 inches (762 mm) above the point where the roof surface and the wall intersect....
-
1132A.4.1 Thresholds
Changes in height at interior door thresholds (e.g., floor material changes at door thresholds) shall not exceed ½ inch (12.7 mm)....
-
T304 Operable Parts
The technical requirements for operable parts include provisions on height, location, and operation....
-
Evaluation of transfers
to the higher heights (Table 13). ...
-
226 Dining Surfaces and Work Surfaces
surfaces covered do not include those surfaces used by employees, since elements of work stations are not required to comply with these guidelines (226.1) exempt sales and service counters...
-
D. Reach Range
[ADA Stds. 5.5] Yes __ No __ N/A __ Comments: ________________________________________ ...operational controls higher than 46" if they are set back 10"-24" from the edge of the counter...
-
Single-User Toilet Rooms: No Side Transfer Space
Lavatory placement is limited by the rear gab bar, which should not overlap counter surfaces....
-
Participants
A total of 73 participants were enrolled consisting of 56 men and 17 women, with an average age of 45 ± 15 years, body weight of 176 ± 53 lbs and a height of 67±6 in....
-
§ 38.159(c)(5) Slope
If the height of the vehicle floor from which the ramp is deployed is 3 inches (75 mm) or less above a 6 inch (150 mm) curb, a maximum slope of 1:4 is permitted; if the height of the vehicle...
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
Side reach (Section-by-Section Analysis)
The 1991 Standards at section 4.2.6 establish a maximum side-reach height of 54 inches. The 2010 Standards at section 308.3.1 reduce that maximum height to 48 inches....
-
Side reach (Section-by-Section Analysis)
The 1991 Standards at section 4.2.6 establish a maximum side-reach height of 54 inches. The 2010 Standards at section 308.3 reduce that maximum height to 48 inches....
-
1132A.4 Level floor or landing
Primary entry doors, required exit doors or secondary exterior doors with changes in height between the interior surface or floor level and the exterior surface or floor level shall comply...
-
611 Washing Machines and Clothes Dryers
Section 611 covers washing machines and clothes dryers and provides specifications for clear floor space, operable parts, and height. Comment....
-
FBD Partnership Three Flavors Frozen Beverage Dispenser
RapidFreeze™ Cold Chamber system improves recovery and draw-time, while reducing compressor run-time Electronic Simplicity offers easy-to-use keypad interface Optimal Use of Counter...
-
FBD Partnership Two Flavors Frozen Beverage Dispenser
RapidFreeze™ Cold Chamber system improves recovery and draw-time, while reducing compressor run-time Electronic Simplicity offers easy-to-use keypad interface Optimal Use of Counter...
-
Clear Floor Space [4.34.2] and Reach Ranges [4.34.3]
Maximum reach heights to controls are based on the approach provided. The reach height applies to all controls and elements available for customer activation....
-
Side Approach
Side Approach Where space is provided for a side approach, controls can be mounted at the heights allowed for side reaches....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
