Figure 608.2.2 Standard Roll-In Type Shower Compartment Size and Clearance...
Search Results "Maneuvering Clearance (Alcove)"
Filters
Commonly Searched Documents
-
608.2.2 Standard Roll-In Type Shower Compartments
-
608.2.3 Alternate Roll-In Type Shower Compartments
Note: inside finished dimensions measured at the center points of opposing sides Figure 608.2.3 Alternate Roll-In Type Shower Compartment Size and Clearance...
-
1009.4.1 Clear Deck Space
Where two grab bars are provided, the clear deck space shall be centered on the clearance between the grab bars. Figure 1009.4.1 Clear Deck Space at Transfer Walls...
-
E2-c
Are any interior stairs along these routes configured with a cane-detectable warning or a barrier that prevents travel into the area with less than an 80-inch high head clearance so that...
-
11B-1009.4.1 Clear deck space
Where two grab bars are provided, the clear deck space shall be centered on the clearance between the grab bars. FIGURE 11B-1009.4.1 CLEAR DECK SPACE AT TRANSFER WALLS...
-
11B-604.8.2.2 Doors
Toilet compartment doors, including door hardware, shall comply with Section 11B-404, except that if the approach is to the latch side of the compartment door, clearance between the door...
-
Kitchens, Kitchenettes, or Wet Bars [9.2.2(7)]
A forward approach to sinks (with knee and toe clearances below) is recommended for sinks that may be used more regularly or for extended periods of time, such as a kitchen in apartment-style...
-
304.3.2 T-Shaped Space
The space shall be permitted to include knee and toe clearance complying with 306 only at the end of either the base or one arm....
-
68.30(3) Van Accessible Parking at Garages Constructed Prior to April 1994
Parking garages where construction was started before April 1, 1994, and the existing vertical clearance of the garage is less than 98”, are exempted from requirements to have van-accessible...
-
4.3.5.3 180-degree turn around an obstacle
The current ADA-ABA standard for the space needed to complete maneuver is based on the width of the entry aisle and the width of the intervening obstacle, e.g. shelving....
-
Station 1-Physical Characteristics
Manual and powered wheelchairs that are built to optimize indoor maneuvering will not be as usable in the outdoor environment....
-
Top Landings
Otherwise, maneuvering at the top of ramps would require turning on the flared sides. Landings must also be as wide as the curb ramp they serve....
-
Baby Changing Tables
The specified dimensions of toilet compartments provide the minimum amount of space necessary for wheelchair maneuvering into the compartment, positioning at the fixture, and exit from the...
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
Description: Entry to wheelchair spaces on raised surfaces greater than ¼ inch in height requires a transition via a bevel or ramp so that people using mobility devices will be able to maneuver...
-
15. Can I store my lift and bring it out only when it is requested by a person with a disability?
In addition, the ADA Standards specify that a lift must be located at the proper water depth and with the necessary space around it to maneuver a wheelchair....
-
Gratings [4.5.4]
Irregular paved surfaces where joint surfaces may be recessed below the level, of the paving unit can disrupt wheelchair maneuvering even if the differences in level are less than ¼ inch...
-
Bicycle Trailers
Safety recommendations in several sources include installing a highflying fluorescent warning flag to increase visibility, allowing plenty of stopping distance, and using caution when maneuvering...
-
Inclusion Solutions Voting Booth Accessories Franklin Voting Chair
Compatible with all accessible voting systems and voting booths. 23.25” chair width is optimal dimension to fit under 32” required minimal ADA clearance space under voting booths...
-
Picnic Tables
All new picnic table installations must comply with requirements for accessible seating spaces, table clearance, slope, and surface....
-
1009.4.1 Clear Deck Space
Where two grab bars are provided, the clear deck space shall be centered on the clearance between the grab bars. Figure 1009.4.1 Clear Deck Space at Transfer Walls...
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at 2013 CBC 11B-806.2.3.1 is not required by 2010 ADAS....
-
Single-User Toilet Rooms: No Side Transfer Space
Door clearances and turning space, as shown in the preceding examples, further determine minimum room dimensions....
-
Is there a minimum distance between changes in level?
Ramps and curb ramps, which must be used to span vertical changes greater than ½”, must have level landings and clearances at the tops and bottoms of each run to provide adequate separation...
-
Protrusion Limits [§307.2]
Those with leading edges that are within cane sweep (27” high maximum) or that provide minimum headroom clearance (80” minimum) do not pose hazards and can protrude any amount....
