Intermediate landings between runs must be at least 60” wide clear and 60” long clear where ramps change direction (any change from linear)....
Search Results "Linear Drain"
Commonly Searched Documents
-
Landings [§405.7]
-
Swimming pools. (Section-by-Section Analysis)
First, the Department is proposing to add § 35.150(b)(5)(ii) to provide that swimming pools that have over 300 linear feet of swimming pool wall and are not being altered will be required...
-
Physical Barriers
Compensating for physical barriers can drain a lot of time and energy....
-
Overview
The 2010 Standards establish two categories of pools: large pools with more than 300 linear feet of pool wall and smaller pools with less than 300 linear feet of wall....
-
Required Compliance [§209]
Required Compliance [§209] Where passenger loading zones are provided, at least one accessible passenger loading zone is required in every continuous 100 linear feet of loading zone or...
-
Installation of Aggregate Surfaces at Bradford Woods
surfaces at Bradford Woods conformed to the following protocol: Prior to installing the crushed rock (aggregate) surfacing material, the trail bed shall be shaped to reflect the same linear...
-
Why test on straight courses and P-shaped turning courses?
Constructing long test courses enables comparison of subject data with research done by other investigators in which subjects walk on a straight linear course or in large diameter circles...
-
Standard Stall
Where floor drains are provided, they should be located or otherwise designed (trench drains) so that the floor surface in accessible stalls is level since slopes greater than 2% and drain...
- Landscape Forms Inc. Max Transportation Stop Shelters
-
Point of Use Water Heaters and Knee Space
Are in line point of use hot water heaters required to be covered/shielded similar to how drains/hot water supply lines are?...
-
Manual vs. Power (RMS Values)
The different slopes of the linear trend lines show that manual WCs will have a greater increase in vibrations for a particular increase in surface roughness than power WCs....
-
606.3 Height
, sinks that are adjustable to variable heights, 29 inches (735 mm) minimum and 36 inches (915 mm) maximum, shall be permitted where rough-in plumbing permits connections of supply and drain...
-
Technical Memorandum TM 2013-22 Storage (Kitchens and Kitchenettes)
Access Board “shelf space” shall be calculated by linear feet and drawers shall be considered shelving for purposes of determining compliance with TAS 804.5....
-
606.3 Height
, sinks that are adjustable to variable heights, 29 inches (735 mm) minimum and 36 inches (915 mm) maximum, shall be permitted where rough-in plumbing permits connections of supply and drain...
- Inpro Corporation JointMaster® DR Series Seal Expansion Joint Systems
- HEWI System 162 Door Hardware
-
Common Problems with Toilet Rooms
Ø The sink has exposed hot water and drain pipes, which can cause serious burns....
-
606.3 Height
, sinks that are adjustable to variable heights, 29 inches (735 mm) minimum and 36 inches (915 mm) maximum, shall be permitted where rough-in plumbing permits connections of supply and drain...
-
Boat Slip Clearance: ADA Standard Section 1003.3.1
Each 10 feet (3050 mm) maximum of linear pier edge serving boat slips shall contain at least one continuous clear opening 60 inches (1525 mm) wide minimum. EXCEPTIONS: 1....
-
Swimming Pools: ADA Standard Section 242.2
Section 242.2 covers scoping requirements in the current ADA Standards for swimming pools.
-
11B-1003.3.1 Boat slip clearance
Each 10 feet (3048 mm) maximum of linear pier edge serving boat slips shall contain at least one continuous clear opening 60 inches (1524 mm) wide minimum....
-
2. What does the ADA require for accessibility of pools?
Section 242 provides that large pools (pools with 300 linear feet of pool wall or more) must have two accessible means of entry and exit....
-
Recommendations for Future Research
• Future research should evaluate energy consumption using both linear travel and ambulation with turns....
-
5.4.2 Transfer Support Length for M301 and M302
This is a linear measurement (see Figure 5.4.1). NPRM Proposed Provision: Length not addressed....