Section 218.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for transportation facilities.
Search Results "Bus"
-
General: ADA Standard Section 218.1
-
Transportation Facilities: ADA Standard Section 218
Section 218 covers scoping requirements in the current ADA Standards for transportation facilities.
-
11B-218.1 General
Transportation facilities shall comply with Section 11B-218.
-
11B-218 Transportation facilities
[See subsections ...]
-
11B-218.1 General
Transportation facilities shall comply with Section 11B-218.
-
11B-218 Transportation facilities
[See subsections ...]
-
T205.1 General
Non-rail vehicles shall provide illumination complying with T503 at ramps, bridgeplates, doorways, and boarding and alighting areas.
-
T404.3 Ramps and Bridgeplates
Where the space between the floor of non-rail vehicles and a boarding platform is greater than 2 inches (51 mm) horizontally or 5/8 inch (16 mm) vertically when measured at 50...
-
II. Rulemaking History
Since that time, new or updated technologies (such as low floor buses, intelligent transportation systems, and automated announcement systems), transit system designs (such as bus rapid...
-
T204.2 Doorways with Lifts, Ramps or Bridgeplates
Doorways with lifts or ramps shall comply with T502.2.
-
§ 38.33 Fare box
Where provided, the fare box shall be located as far forward as practicable and shall not obstruct traffic in the vestibule, especially wheelchairs or mobility aids.
-
11B-209 Passenger drop-off and loading zones and bus stops.
[See subsections ...]
-
T207.2 Passenger Doorways
Handrails or stanchions shall be provided at passenger doorways in a configuration that permits grasping and use from outside the non-rail vehicle and throughout the boarding and...
-
T204.3 Doorways with Level Boarding and Alighting
Doorways with level boarding and alighting shall comply with T502.3.
-
T402.9 Transitions
Vertical surface discontinuities at transitions from boarding and alighting areas to ramps and bridgeplates shall comply with T302.4.
-
T202.1 General
Non-rail vehicles shall provide at least one means of accessible boarding and alighting that serves each designated stop on the fixed route to which the vehicle is assigned. Non-rail...
-
Costs and Benefits
requirement, the Final RA models costs using three prototypical size-based categories—which are denominated Tiers I, II and III—that are intended to be representative of the range of fixed route bus...
-
Level boarding
If not using a lift or ramp to provide level boarding, the grantee must submit to FTA a demonstration of equivalent facilitation. (DOT ADA Regulation 49 C.F.R. 37.7(b) and DOT ADA...
-
10.2.1(1)
(1) Where new bus stop pads are constructed at bus stops, bays or other areas where a lift or ramp is to be deployed, they shall have a firm, stable surface; a minimum clear length of 96...
-
T204.1 General
Doorways on non-rail vehicles shall comply with T204.
-
T210.4 Location
Wheelchair spaces shall be located as near as practicable to doorways that provide a means of accessible boarding and alighting.
-
T204 Doorways
[See subsections ...]
-
T203.1 General
Steps on non-rail vehicles shall comply with T405.
-
CHAPTER 2: SCOPING REQUIREMENTS
[See subsections ...]