Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or supporting...
Search Results "Transfer Support"
Filters
Commonly Searched Documents
-
11B-610.4 Structural strength
-
410.6 Real-Time Text Functionality (Section-by-Section Analysis)
Proposed 410.6 would require that, where ICT supports real-time voice communication, it must also support RTT functionality....
-
4.5 Other Tips for Making Equipment More Useable
Once you have transferred onto a piece of exercise equipment you can use a strap (such as a long piece of Velcro or an extra-long belt) as a “seat belt” to help you balance....
-
M304.2 Standing Surface (Section-by-Section Analysis)
The requirement for slip resistant and standing supports has been moved under this new requirement applying to standing surfaces....
-
5.8.2.4 Unobstructed Floor Space Recommendation
The base support affects how close the patient can get to the mammography machine because it intrudes into the floor space....
-
M302.1 General
Diagnostic equipment that supports patients in a seated position shall comply with M302. ...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or supporting...
-
§ 1194.2(a)(2)
(2) When procuring a product, if an agency determines that compliance with any provision of this part imposes an undue burden, the documentation by the agency supporting the procurement...
-
4.26.3(3)
Shear force induced in a fastener or mounting device from the application of 250 lbf (1112N) shall be less than the allowable lateral load of either the fastener or mounting device or the supporting...
-
11B-609.8 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the grab bar, fastener, mounting device, or supporting...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or supporting...
-
PART 3: ACCESSIBLE EXAMINATION ROOMS
.); and adequate clear floor space inside the room for side transfers and use of lift equipment....
-
Protrusion Limits: ADA Standard Section 307.2
Section 307.2 covers the current ADA Standards for protrusion limits.
-
Classroom Acoustics: ADA Standard Section 6.
Review the updated information on the revisions to the ADA Standards regarding classroom acoustics.
-
Toe Clearance: ADA Standard Section 604.8.1.4
Section 604.8.1.4 covers the current ADA Standards for toe clearance at wheelchair accessible compartments.
-
11B-307.2 Protrusion limits
For example, awnings and their supporting structures cannot reduce the minimum required vertical clearance....
-
I. Introduction
The purpose of this Minority Report is to make a formal recommendation for a minimum transfer surface low height of 19 inches for diagnostic imaging medical equipment....
-
Connections [1018.2]
Whenever possible, providing a beach access route that extends into the water will allow people to remain in their mobility devices and to transfer directly into the water....
-
2. Roll-in Shower Size
more than 50 guestrooms/suites, are all required roll-in showers at least 30" wide by 60" long or 36" wide by 60", as configured in Figure 57 below, so persons who use wheelchairs may transfer...
-
Size and Clearances [4.21.2]
Recommendation: Twelve inches of additional clear floor space at the seat will facilitate side transfers....
-
Irwin Seating Company ADA Swing-Away Aisle Panels
Many aisle end panels can be manufactured to swing open to allow an individual to transfer between a wheelchair and the theatre chair....
-
Guest Bathrooms
In transfer-type showers, the seat shall extend from the back wall to a point within 3 inches (75 mm) of the compartment entry....
-
H. Barriers Affecting Accessibility and Usability of Medical Diagnostic Equipment
., stiffness, comfort, color contrast), supports for transferring onto and off of equipment and positioning their bodies on the equipment (e.g., handholds, armrests, side rails), controls...
-
11B-602.5 Spout location
The spout shall be located 15 inches (381 mm) minimum from the vertical support and 5 inches (127 mm) maximum from the front edge of the unit, including bumpers. ...
