Walkways shall be of sufficient width to accommodate the pedestrian traffic, but in no case shall they be less than 4 feet (1219 mm) in width....
Search Results "Compartment Width"
Filters
Commonly Searched Documents
-
3306.2 Walkways
-
A MINIMUM HIGHEST POINT STANDARD OF 19 INCHES IS CONSISTENT WITH EXISTING ACCESSIBILITY STANDARDS
Permanent seats shall be positioned at the head end of the bathtub.14 Nineteen-inch high shower compartment seats are accessible: 610.3 Shower Compartment Seats....
-
2. Shoulder Breadth
Shoulder Breadth Shoulder breadth tends to be slightly greater than hip or thigh breadth and hence was used as an estimate for the width of an examination table when in a reclined position...
-
Taking Measurements
Measuring slope using a 24-inch level and tape measure Using the Tape Measure When measuring the width of a parking space or access aisle, the width of an accessible route or the height...
-
T402.5 Surfaces
Ramp and bridgeplate surface material shall comply with T302 and extend across the full width and length of the ramp or bridgeplate....
-
11B-705.1.2.5 Blended transitions
Detectable warnings at blended transitions shall be 36 inches (914 mm) in width....
-
11B-806.2.4 Toilet and bathing facilities
In addition, required roll-in shower compartments shall comply with Section 11B-608.2.2 or 11B-608.2.3....
-
225 Storage
Since this provision is specific to certain types of spaces, it is now located among scoping requirements covering toilet rooms and compartments (213.3.8), and dressing, fitting, and locker...
-
907.2.6.2.3 Smoke detectors
Smoke detectors are not required in sleeping rooms with four or fewer occupants in smoke compartments that are equipped throughout with an approved automatic sprinkler system....
-
A4.10.14 Emergency Communications
Also, small handles on handset compartment doors are not usable by people who have difficulty grasping....
-
11B-806.2.4 Toilet and bathing facilities
In addition, required roll-in shower compartments shall comply with Section 11B-608.2.2 or 11B-608.2.3....
-
11B-806.2.4 Toilet and bathing facilities
In addition, required roll-in shower compartments shall comply with Section 11B-608.2.2 or 11B- 608.2.3....
-
Magnuson Group UMEA Waste Receptacles
Constructed of painted steel and suitable for both indoors and outdoors, UMEA models can be 1, 2 or 3-compartments wide – each with selectable top inserts and corresponding front graphics...
-
Door Maneuvering Clearance
The final rule includes clarification, which was partially contained in a previous footnote to Table 404.2.4.1, that maneuvering clearances "shall extend the full width of the doorway and...
-
403 Walking Surfaces
Section 403.5 includes requirements for the clear width of walking surfaces....
-
Clearance Around Base (M301.4.2 and M302.4.2)
The width of the base permitted within this clearance would be 26 inches wide maximum at the edge of the examination surface and is permitted to increase at a rate of 1 inch in width for...
-
11B-812.6 Vehicle spaces
All vehicle spaces shall be marked to define their width. Exceptions: 1....
-
11B-812.6 Vehicle spaces
All vehicle spaces shall be marked to define their width....
-
5.8.1.1 Clear Platform Size
The platform should be a minimum clear width of 32-inches and a minimum clear length of 40-inches....
-
Technical Requirements
Are the specific numbers, conditions, and measurements that are required to be achieved (percent that must comply, dimensions, reach ranges, grades, trail width, etc.)....
-
Technical Requirements
The specific numbers, conditions, and measurements that are required to be achieved (percent that must comply, dimensions, reach ranges, grades, trail width, etc.). ...
-
11B-705.1.2.5 Hazardous vehicular areas
Detectable warnings at hazardous vehicular areas shall be 36 inches (914 mm) in width....
-
11B-812.8.7 Location
Signs shall be permanently posted either immediately adjacent to the vehicle space or within the projected vehicle space width at the head end of the vehicle space....
