Mounts against side wall in accessible toilet compartment to allow clearance for grab bar above unit has toilet tissue dispenser on right side of unit....
Search Results "Compartment Width"
Filters
Commonly Searched Documents
-
Bobrick B-30929 ClassicSeries® Surface-Mounted Toilet Tissue, Seat-Cover Dispenser and Waste Disposal
-
Three-Point Turn
three-point turn width required by bicyclists was 287 cm (113 inches)....
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
11B-404.2.4 Maneuvering clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance. Exception: Reserved....
-
Passing Spaces on Trails
A 60-inch (1,525-millimeter) clear tread width is required for two wheelchairs to pass safely and comfortably on a trail....
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
Bobrick B-30919 ClassicSeries® Surface-Mounted Toilet Tissue, Seat-Cover Dispenser and Waste Disposal
Mounts flush against side wall in accessible toilet compartment to allow clearance for grab bar above unit has toilet tissue dispenser on left side of unit....
-
COST OF EQUIPMENT
Price Price Increase Configuration #1: Accessible equipment as currently available on the market, standard chair arms and stirrups 19 inch max. height 28 inch width...
-
T302.3 Openings
Wheelchair securement system components affixed to walking surfaces shall be permitted to have openings 7/8 inch (22 mm) maximum in width provided that, where such openings are more than...
-
Wheelchair Spaces
Wheelchair spaces should not overlap required exit widths or circulation paths and should provide for shoulder-to-shoulder alignment with occupants of adjacent seats (an important consideration...
-
11B-812.10.4 Location
EV chargers shall be adjacent to, and within the projected width of, the vehicle space being served....
-
Flush Controls
The final rule includes a requirement that "flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments" (604.6)....
-
102 Dimensions for Adults and Children
In addition, technical requirements are also provided based on children’s dimensions and anthropometrics for drinking fountains, water closets and other elements located in toilet compartments...
-
Over-the-Road Bus
The ADA definition focuses on a bus with an elevated passenger deck over a baggage compartment (i.e., a "Greyhound-type'' bus)....
-
502.1 General
Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline of the markings....
-
502.1 General
Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline of the markings....
-
A4.13.9 Door Hardware
To be effective, they should cover the door width, less approximately 2 in (51 mm), up to a height of 16 in (405 mm) from its bottom edge and be centered across the width of the door....
-
502.1 General
Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline of the markings....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
Salsbury Industries See Through Metal Locker Double Tier 3 Wide
unassembled or assembled (additional charge for assembled) Feature a durable powder coated finish available in gray, tan or blue Available in 6 foot height (add 6" for legs) Units have compartment...
-
Salsbury Industries See Through Metal Locker Double Tier 1 Wide
unassembled or assembled (additional charge for assembled) Feature a durable powder coated finish available in gray, tan or blue Available in 6 foot height (add 6" for legs) Units have compartment...
