(2) Free-standing or built-in units not having a clear space under them shall have a clear floor space at least 30 in by 48 in (760 mm by 1220 mm) that allows a person in a wheelchair to...
Search Results "Ground Floor Exit"
Filters
Commonly Searched Documents
-
4.15.5(2)
-
4.15.5(2)
(2) Free standing or built-in units not having a clear space under them shall have a clear floor space at least 30 in by 48 in (760 mm by 1220 mm) that allows a person in a wheelchair to...
-
11B-612.2 Bench
Doors shall not swing into the clear floor space required by Section 11B-903.2....
-
Judicial Facilities: ADA Standard Section 231
Section 231 covers scoping requirements in the current ADA Standards for judicial facilities.
-
General: ADA Standard Section 231.1
Section 231 of the ADA Standards covers information in the current ADA Standards on scoping requirements for judicial facilities.
-
11B-231.1 General
Judicial facilities shall comply with Section 11B-231.
-
11B-231 Judicial facilities
[See subsections ...]
-
11B-703.5.5 Character height
Exception: Where provided, floor plans providing emergency procedures information in accordance with Title 19 shall not be required to comply with Section 11B-703.5.5....
-
11B-703.5.5 Character height
Exception: Where provided, floor plans providing emergency procedures information in accordance with Title 19 shall not be required to comply with Section 11B-703.5.5....
-
11B-703.5.5 Character height
Exception: Where provided, floor plans providing emergency procedures information in accordance with Title 19 shall not be required to comply with Section 11B-703.5.5....
-
4.10.5 Raised and Braille Characters on Hoistway Entrances
All elevator hoistway entrances shall have raised and Braille floor designations provided on both jambs. The centerline of the characters shall be 60 in (1525 mm) above finish floor....
-
Are employee restrooms and break rooms required to be accessible?
Areas used only by employees for work are not required to be fully accessible but must be connected by accessible routes and means of egress for approach, entry, and exit and have wiring...
-
405.4 Floor or Ground Surfaces
405.4 Floor or Ground Surfaces. Floor or ground surfaces of ramp runs shall comply with 302....
-
10.3.1(19)
Gates which must be pushed open by wheelchair or mobility aid users shall have a smooth continuous surface extending from 2 inches above the floor to 27 inches above the floor....
-
Employee Work Areas [§203.9]
At a minimum, areas used only by employees as work areas must meet requirements for: access to approach, entry, and exit the work area (§203.9) accessible means of egress...
-
11B-233.3.1.2.6 Public housing facility site impracticality
ETA Editor's Note This section of the 2019 California Building Code was amended by the Division of the State Architect. The requirements in this section were previously found in...
-
29.1 Q. Is it acceptable to design a bathroom with an in-swinging 2'10 door which can be retrofitted to swing out in order to provide the necessary clear floor space in the bathroom?
Thus, for a bathroom, there must be sufficient maneuvering space and clear floor space so that a person using a wheelchair or other mobility aid can enter and close the door, use the fixtures...
-
Clear floor space beside or between beds must be 36" wide
Remember that because the clear floor space required by 806.2.3 will be deeper than 24" to end up beside or between the beds where it will be usable, it will be in an alcove that is at least...
-
11B-240.2 Play components
Where provided, play components shall comply with Section 11B-240.2.
-
F240.2 Play Components
Where provided, play components shall comply with F240.2.
-
240.2 Play Components
Where provided, play components shall comply with 240.2.
-
R404.2 Surfaces
R404.2 Surfaces. Surfaces of clear spaces shall comply with R302.7 and shall have a running slope consistent with the grade of the adjacent pedestrian access route and cross slope of...
-
240.2 Play Components
240.2 Play Components. Where provided, play components shall comply with 240.2.
-
Rotational Penetrometer Measurements of Firmness and Stability
Rotational Penetrometer Measurements of Firmness and Stability. The Rotational Penetrometer penetrated significantly more on the dirt (DIRP), chipped brush (CPBR), engineered wood...