Deliberate manipulation of the height of the finished floor level to avoid the requirements of the Fair Housing Act would serve as a basis for the Department to determine that there is reasonable...
Search Results "Court Floor Holding Cell"
-
12.2 Q. What happens if a builder deliberately manipulates the grade so that a second story, which also might have been treated as a ground floor, requires steps?
-
4.1.3 Wheelchair Seating Space
Clear floor or ground space that is at least 30 inches by 48 inches shall be provided at each seating space that is required to be accessible and positioned for a forward approach to the...
-
1(2)(a)(ii) Site analysis test
(B) To determine the practicality of providing accessibility to planned multifamily dwellings based on the topography of the existing natural terrain, the minimum percentage of ground floor...
-
Problem One (Voting Area)
Problem One: The voting area is in a small room and the accessible voting machine is only two feet from the check-in table. Solution: Relocate the voting area to a larger space...
-
1134A.8, Item 4
4. Knee and toe space. Knee and toe space shall be provided by one of the following:
-
3.4.7 Openings
Openings in the clear ground space and turning space surface shall not allow passage of a sphere more than 1/2 inch (13 mm) diameter. Where possible, elongated openings should be...
-
5.1.7 Surface
The surface of the clear ground space shall be firm and stable.
-
1134A.8, Item 4
4. Knee and toe space. Knee and toe space shall be provided by one of the following:
-
Inpro Corporation JointMaster® AR Series Seal Expansion Joint Systems
Requires the Premium User plan or above. (Login or upgrade your account!)
-
Inpro Corporation JointMaster® DR Series Seal Expansion Joint Systems
Requires the Premium User plan or above. (Login or upgrade your account!)
-
1008.2.6 Ground Surfaces
Ground surfaces on accessible routes, clear floor or ground spaces, and turning spaces shall comply with 1008.2.6. Advisory 1008.2.6 Ground Surfaces....
-
Alterations and water closet clearances in single-user toilet rooms with in-swinging doors. (Section-by-Section Analysis)
The 1991 Standards do not allow an in-swinging door in a toilet or bathing room to overlap the required clear floor space at any accessible fixture....
-
1023.9 Stairway identification signs
A sign shall be provided at each floor landing in an interior exit stairway and ramp connecting more than three stories designating the floor level, the terminus of the top and bottom of...
-
1023.9 Stairway identification signs
In addition to the stairway identification sign, raised characters and braille floor identification signs that comply with Chapter 11A, Section 1143A or Chapter 11B shall be located at the...
- American Standard Acrylic Shroud for American Standard Selectronic Faucets
- Access Board: Accessible Route Carpet
-
Plan 5B: 13-Foot Wide Accessible Guest Room
Lavatory with vanity counter top recessed to permit shorter rear grab bar at water closet (section 604.5.2); • T-shaped turning space in room (section 603.2.1); • Required clear floor...
-
1022.9 Stairway identification signs
In addition to the stairway identification sign, raised characters and braille floor identification signs that comply with Chapter 11A, Section 1143A or Chapter 11B, Sections 11B-703.1,...
-
Key Study findings:
. the 5th percentile or approximately 95% of the study sample) could transfer independently to a platform at a height that was within one inch of the mean wheelchair or scooter seat to floor...
-
Plan 4A: 13-Foot Wide Accessible Guest Room
accessible features are provided in the bathroom: • Comparable vanity counter top space (section 806); • Standard roll-in type shower with folding seat (section 608.2.2); • Clear floor...
-
Detention and Correctional Facilities: ADA Standard Section 203.7
Section 203.7 covers scoping requirements of general exceptions for detention and correctional facilities in the most current ADA Standards.
-
11B-803.3 Door swing
Doors shall not swing into the room unless a turning space complying with Section 11B-305.3 is provided beyond the arc of the door swing.
-
Highway standards suggesting possible applications for pedestrian surfaces
ASTM E 950-98(2004) Standard test method for measuring the longitudinal profile of traveled surfaces with an accelerometer established inertial profiling...
-
11B-803.3 Door swing
Doors shall not swing into the room unless a turning space complying with Section 11B-305.3 is provided beyond the arc of the door swing.