Each provision specifies the type of assistive technology that must be supported....
Search Results "Vertical Standing Support"
Commonly Searched Documents
-
Section 1194.31 Functional Performance Criteria (Preamble, Section-by-Section Analysis)
-
410.8 Video Communication (Section-by-Section Analysis)
410.8 Video Communication (Section-by-Section Analysis) This section proposes that ICT with real-time video functionality must ensure that the quality of the video is sufficient to support...
-
4.1.1 Range of Examination Table and Chair Configurations
Therefore, tables and chairs must support a wide range of diagnostic activities, clinical indications, and patient populations....
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
Subpart D requires that: (a) product support documentation provided to end users shall be made available in alternate formats upon request at no additional charge; (b) end users shall have...
-
68.31. Variance Procedures
(b) Variance Applications shall be accompanied by the applicable fee, plans of all affected areas, and any supporting documentation such as photos, cost analyses, and code references....
- Stanley QRM 100 Series Grade 1 Extra Heavy Duty Exit Devices
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
Based on currently marketed products, we estimate the following costs: Transfer Supports (TS): $500 - $1,000 (M301.3.1) Leg Supports (LS): $700 - $1,100 (M301.3.2)...
-
§8.3 Qualified individual with handicaps
requirements that an occupant of multifamily housing be capable of meeting the recipient's selection criteria and be capable of complying with all obligations of occupancy with or without supportive...
-
Need for This Technical Assistance
investigation arose from a complaint that a mother with a developmental disability was subject to discrimination on the basis of her disability because the State did not provide her with supports...
-
9 [§ 4.7.5]
9 [§ 4.7.5] Curb ramps either have flared sides or vertical edges called returned curbs....
-
608.7 Thresholds
In transfer type shower compartments, thresholds ½ inch (13 mm) high maximum shall be beveled, rounded, or vertical....
-
23.1 Q. What type of reinforcement should be used to reinforce bathroom walls for the later installation of grab bars?
that grab bar reinforcing may be accomplished in a variety of ways, such as by providing plywood panels in the areas illustrated in the Guidelines under Requirement 6, or by installing vertical...
-
608.7 Thresholds
In transfer type shower compartments, thresholds ½ inch (13 mm) high maximum shall be beveled, rounded, or vertical....
-
Egress, Means of
A means of egress comprises vertical and horizontal travel and may include intervening room spaces, doorways, hallways, corridors, passageways, balconies, ramps, stairs, enclosures, lobbies...
-
68.30(3) Van Accessible Parking at Garages Constructed Prior to April 1994
Parking garages where construction was started before April 1, 1994, and the existing vertical clearance of the garage is less than 98”, are exempted from requirements to have van-accessible...
-
§ 38.53(d)(1) Requirements
Vertical alignment may be accomplished by vehicle air suspension or other suitable means of meeting the requirement....
-
11B-703.6.1 Pictogram field
The 6-inch vertical dimension applies to the field, not the symbol. The symbol may be smaller than the field....
-
§ 38.29(e)
(e) For vehicles in excess of 22 feet in length with front-door lifts or ramps, vertical stanchions immediately behind the driver shall either terminate at the lower edge of the aisle-facing...
-
11B-608.7 Thresholds
In transfer type shower compartments, thresholds ½ inch (12.7 mm) high maximum shall be beveled, rounded, or vertical....
-
10. Other Accommodations
for people with mental retardation and other disabilities who benefit from individualized on-the job training and services provided at no cost by vocational rehabilitation agencies in "supported...
-
COST OF EQUIPMENT
depth $5,000 - $9,000 $7,000 0% (baseline) Configuration #2: Accessible equipment as currently available on the market, with the addition of transfer supports...
-
E. EMERGENCY MANAGEMENT PROCEDURES AND POLICIES
Attorney's Office, including all supporting documents, within 30 days of its being available (a guide for emergency preparedness and the ADA can be found at: http://www.ada.gov/emergencyprepguide.htm...
-
Press Boxes: ADA Standard Section 206.2.7
Section 206.2.7 covers scoping requirements in the most current ADA Standards for accessible routes to press boxes.
-
11B-206.2.7 Press boxes
An accessible route shall not be required to free-standing press boxes that are elevated above grade 12 feet (3660 mm) minimum provided that the aggregate area of all press boxes is 500...