The width of the level area at the exterior side of the primary entry door and any required exit doors shall comply with Section 1126A. Notes: 1....
Search Results "Sloped Entry"
-
1132A.5.2 Strike edge maneuvering space at doors
-
§ 38.95(a)(1) General
All new commuter rail cars, other than level entry cars, covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift, ramp or bridge plate) complying with...
-
1016.8 Resting Intervals
This section contains the technical requirements for the length (1016.8.1), width (1016.8.2), and slope (1016.8.3) of resting intervals; and for a turning space (1016.8.4) where resting...
-
Raised Crossings
Consult local Standards for application requirements, including slope for vehicle traffic, height, and markings....
-
Using the Beach Access Route Exceptions [1018.1, Exceptions 1 and 2]
Removable Beach Access Route Requirements Removable beach access routes are not required to comply with the specific requirements for running slope, cross slope, resting intervals, and...
-
R105 Definitions (Section-by-Section Analysis)
The proposed guidelines define the following terms: accessible, alteration, blended transition, cross slope, curb line, curb ramp, element, facility, grade break, operable part, pedestrian...
-
Grade (R302.5) (Section-by-Section Analysis)
Grade (R302.5) (Section-by-Section Analysis) Grade is the slope parallel to the direction of pedestrian travel....
-
When Ramps Are Required
A ramp run is a length of a continuous sloped surface that is ascending or descending....
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. Exception: Parallel curb ramps shall not be required to comply with Section 11B-406.5.3....
-
Exceptions When Conditions Do Not Permit Full Compliance
The regulatory negotiation committee report used the example of constructing a portion of a trail in a steeply sloped area, where complying with the provision for running slope would require...
-
Recommended Objective Test Method and Performance Specifications
Performance Specifications The objective test method using the Rotational Penetrometer is recommended because it provides valid and reliable measurements of surface firmness and stability on slopes...
-
Tobin Passage Levers Door Hardware
Functions available: entry, privacy, passage, half dummy...
-
T402.8.1 Deployment to Roadways or to Curb Height Boarding and Alighting Areas
The running slope of ramps and bridgeplates used for deployment to the roadway or to curb-height boarding and alighting areas shall be 1:6 maximum, as measured to ground level with the non-rail...
-
11B-809.5.5.2 Identification
A means for visually identifying a visitor without opening the residential dwelling unit entry door shall be provided and shall allow for a minimum 180 degree range of view....
-
Pool Lifts
If the entire pool is deeper than 48 inches, an exception allows operators to use a pool lift in any location as an accessible means of entry. ...
-
G. Areas of Rescue Assistance
hotels that do not have a supervised fire sprinkler system serving every room, are there two 30"x48" wheelchair waiting areas (a.k.a. an "area of rescue assistance" linked to the primary entry...
-
608.2.3 Alternate Roll-In Type Shower Compartments
A 36 inch (915 mm) wide minimum entry shall be provided at one end of the long side of the compartment....
-
809.5.5.2 Identification
A means for visually identifying a visitor without opening the residential dwelling unit entry door shall be provided and shall allow for a minimum 180 degree range of view....
-
407.3.3 Numeric Keys (Section-by-Section Analysis)
The intent of this section is to address identification and orientation when numeric data entry is used....
-
11B-809.5.5.2 Identification
A means for visually identifying a visitor without opening the residential dwelling unit entry door shall be provided and shall allow for a minimum 180 degree range of view....
-
1130A.1 General
The accessible route shall pass through the primary entry door, and shall connect with all additional exterior doors, required clear floor spaces at kitchen appliances and bathroom fixtures...
-
11B-809.5.5.2 Identification
A means for visually identifying a visitor without opening the residential dwelling unit entry door shall be provided and shall allow for a minimum 180 degree range of view....
-
1130A.1 General
The accessible route shall pass through the primary entry door, and shall connect with all additional exterior doors, required clear floor spaces at kitchen appliances and bathroom fixtures...
-
1007.3.1 Start of Play
A clear floor or ground space 48 inches (1220 mm) minimum by 60 inches (1525 mm) minimum with slopes not steeper than 1:48 shall be provided at the start of play....
