Because those cross-references to the 1991 Standards are no longer applicable, it is necessary in this final rule to provide new regulatory text....
Search Results "Cross Slope"
-
Section 36.405 Alterations: Historic Preservation (Section-by-Section Analysis)
-
Setting
For example, the design for a trail crossing a glacial boulder field must protect the geologic features....
-
F248.2 Minimum Number
Pedestrian access points to a beach include parking facilities that serve beaches, dune crossings, and stairways or ramps leading from boardwalks to the beach....
-
Why are detectable warnings no longer required for all curb ramps or at hazardous vehicular areas?
At facilities located on sites, various measures can help reduce hazards, including reduced traffic speeds, marked crossings with pedestrian right-of-way, and speed-bumps, and other optional...
-
221.9 Stadium Style Movie Theaters
Wheelchair spaces and companion seats shall be located on a riser or cross-aisle in the stadium section that satisfies at least one of the following criteria: (i) It is located within the...
-
4.13.8* Thresholds at Doorways
Raised thresholds and floor level changes at accessible doorways shall be beveled with a slope no greater than 1:2 (see 4.5.2)....
-
Head Room [4.4.2]
This is important at open stairways and along sloped walls....
-
Special Technical Provisions for Alterations to Existing Buildings and Facilities [4.1.6(3)]
Section 4.1.6(3) recognizes certain allowances where technical feasibility is encountered, such as steeper slopes for short ramps....
-
4.13.8* THRESHOLDS AT DOORWAYS
Raised thresholds and floor level changes at accessible doorways shall be beveled with a slope no greater than 1:2 (see 4.5.2)....
-
11B-608.9 Shower floor or ground surface
Floor or ground surfaces of showers shall comply with Section 11B-302.1 and shall be sloped 1:48 maximum in any direction....
- Independence Associates, Inc. (IA) - East Bridgewater, MA
-
Installation of Test Surfaces
All roots, stones, and vegetation were removed. 2) Place a diversion along the slope above the test area to assure no direct site drainage into the surfaced area. 3) Cover entire subgrade...
-
1016.4 Passing Spaces
Where passing spaces and resting intervals overlap, the technical requirements for resting intervals in 1016.8.3 require the slope of the surface to not be steeper than 1:48 in any direction...
- UMEA Waste Receptacle
-
1009.2.2 Seat Location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48. Figure 1009.2.2 Pool Lift Seat Location...
-
A1
Is a relatively level (1:50 or 2% maximum slope in all directions) access aisle provided adjacent and parallel to the side of the vehicle pull-up area?...
-
810 Transportation Facilities
The Board has explicitly specified that rail platforms shall slope no more than 1:48 in any direction, consistent with cross slope provisions for walking surfaces in section 403....
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
M303.3.3.1 Running Slope. Ramp runs shall have a running slope no steeper than 1:12. M303.3.3.4 Edge Protection....
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
- Willoughby Industries ASHS-1013-06-15-HC Ligature-Resistant 15" wide Lavatory
- Sargent 8200 Mortise Lock with BHL Trim
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48. FIGURE 11B-1009.2.2 POOL LIFT SEAT LOCATION...
-
R409.10.3 Bottom Extension at Stairways
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....