Checklist for Readily Achievable Barrier Removal Easy-to-use survey tool for identifying barriers in facilities....
Search Results "Barrier Wall"
Filters
Commonly Searched Documents
-
4. a. ACCESS GUIDANCE DOCUMENTS
-
2.3 Use a Universal Design Approach
Explain that making the changes you need would be helpful for many of their members. 5 Here are some points you can use: Removing barriers could increase their membership...
-
11B-608.4 Seats
Exception: In residential dwelling units, seats shall not be required in shower compartments provided that reinforcement has been installed in walls so as to permit the installation of seats...
-
11B-805.7 Built-in cabinets and work surfaces
California, issued Code Application Notice CAN 2-11B, dated 9/9/14, which includes the following interpretation of Section 11B-805.7: Built-in equipment consoles include recessed or wall...
-
11B-604.3.2 Overlap
Exception: In residential dwelling units, a lavatory complying with Section 11B-606 shall be permitted on the rear wall 26 inches (660 mm) minimum from the water closet centerline to allow...
-
11B-604.8.2.3 Grab bars
A side-wall grab bar complying with Section 11B-604.5.1 shall be provided on both sides of the compartment....
-
III. STRUCTURAL MODIFICATIONS TO WHC BUILDINGS AND FACILITIES
Final Barrier Removal Report....
-
Q3.) What are the types of “manufacturing processes” that were anticipated where the advisory says “tolerances recognized by this provision include… “those that may be a necessary consequence of a particular manufacturing process”?
Similarly, the surfaces of ceramic tiles that form the wall behind a grab bar will not be perfectly flat due the manufacturing processes that make them. ...
-
608.3 Grab Bars
shower located in a bathing facility for a single occupant accessed only through a private office, and not for common use or public use provided that reinforcement has been installed in walls...
-
608.3 Grab Bars
shower located in a bathing facility for a single occupant accessed only through a private office, and not for common use or public use provided that reinforcement has been installed in walls...
-
Grab Bars [4.16.4]
It must be 36 inches long minimum, installed with one end space a maximum of 6 inches from the side wall....
-
Sec. 469.057(c)
(c) The department may enter into cooperative agreements to integrate information about the architectural barriers program with information produced or distributed by other public entities...
-
11B-608.3 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-608.3.2 or 11B-608.3.3...
-
11B-608.3 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-608.3.2 or 11B-608.3.3...
-
11B-809.12 Electrical receptacles, controls and switches
Where receptacles are provided in a kitchen at a corner work surface, one receptacle shall be located 36 inches (915 mm) from either wall at the inside corner....
-
11B-608.3 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-608.3.2 or 11B-608.3.3...
-
Alternative Designs
The 24" high sides make it impossible to install the two grab bars on the back wall in the manner prescribed in ADAAG....
-
Guidelines for Requirement 6
The Guidelines for Requirement 6 present design standards for installation of reinforcement in bathroom walls to allow for later installation of grab bars around the toilet, tub, shower...
-
Temporary Measures
Temporary Measures While permanently removing architectural barriers is preferable, this document provides some low-cost, temporary solutions that can provide temporary access for people...
-
1017.9 Protruding Objects
This section requires constructed elements on trails, resting intervals, and passing spaces to comply with the technical requirements for protruding objects in 307 of the Architectural Barriers...
-
1) Historic buildings
Contains requirements for buildings eligible for listing in the National Register of Historic Places under the National Historic Preservation Act that are also subject to the Architectural Barriers...
-
1133A.2.1 Clear width
measured between any cabinet, countertop or the face of any appliance (excluding handles and controls) that projects into the kitchen and the opposing cabinet, countertop, appliance or wall...
-
1009 Swimming Pools, Wading Pools, and Spas
Specifications are provided for various means of providing pool access, including pool lifts, sloped entries, transfer walls, transfer systems, and stairs....
-
Uncaptioned audio-only programs
The Museum will continue to provide scripts or wall text for those programs with audio only tracks and will advertise that this service is available and how to access it....