The length of accessible spaces is not specified. Access aisles must be as long as the parking space....
Search Results "Ramp Length"
Filters
Commonly Searched Documents
-
Parking Spaces [4.6.3]
-
Figure 406.2 Counter Slope of Surface Adjacent to Curb Ramps – Drawing from the U.S. Access Board
-
Turning Space: ADA Standard Section 808.2
Where provided, areas that are raised or depressed and accessed by ramps or platform lifts with entry ramps shall provide unobstructed turning space complying with 304....
-
11B-808.2 Turning space
Where provided, areas that are raised or depressed and accessed by ramps or platform lifts with entry ramps shall provide unobstructed turning space complying with Section 11B-304....
-
M305.3.1.2 Diagnostic Equipment Containing a Wheelchair Space
On diagnostic equipment containing wheelchair spaces with one entry that also serves as the exit, the length of the gripping surface of horizontal standing supports shall be equal to or...
-
11B-809.9.4 Work surfaces
Work surfaces shall be 36 inches (914 mm) maximum above the finish floor with minimum lengths at the following locations as required by this section: Linear length of 30 inches...
-
11B-809.10.6.3 Floor space
A clear maneuvering space 30 inches (762 mm) wide minimum by 48 inches (1219 mm) minimum in length shall be located outside the shower, with the width flush with the control wall and the...
-
ACCESSIBLE ROUTE
Interior accessible routes may include corridors, hallways, floors, ramps, elevators and lifts....
-
ASME: ADA Standard Section 105.2.2
Section 105.2.2 of the ADA Standards cover references to the American Society of Mechanical Engineers (ASME) standards.
-
Sloped Surfaces
Measuring the slope of a ramp, parking space, pedestrian route, or other ground or floor surface is important to identify whether the surface is accessible....
-
Counter Slope: ADA Standard Section 406.2
Section 406.2 covers the current ADA Standards for counter slope of adjoining gutters and road surfaces immediately adjacent to curb ramps.
-
Suggested accessibility guidelines for exterior concrete surfaces
Suggested accessibility guidelines for exterior concrete surfaces Current standards for ramps, sidewalks, and intersections and other concrete tolerances are given in ACI 117, Specification...
-
Feature 2 - Routes to the Building Entrance
An accessible route is at least 36 inches wide for the entire length of the route....
-
11B-802.1.3 Depth
wheelchair location space with side entry must functionally be usable as if it were within an alcove, requiring the user to maneuver back and forth to get into position, and thus 60 inches in length...
-
11B-812.7 Access aisle
Access aisles shall be 60 inches (1524 mm) wide minimum and shall extend the full required length of the vehicle spaces they serve....
-
11B-805.4.1 Beds, exam tables, procedure tables, gurneys and lounge chairs
A 36 inch (914 mm) minimum wide clear space shall be provided along the full length of each side of beds, exam tables, procedure tables, gurneys and lounge chairs....
-
11B-812.9 Surface marking
centerline of the text shall be a maximum of 6 inches (152 mm) from the centerline of the vehicle space and its lower corner at, or lower side aligned with, the end of the vehicle space length...
-
EXIT
Exit components include exterior exit doors at the level of exit discharge, interior exit stairways and ramps, exit passageways, exterior exit stairways and ramps and horizontal exits....
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Lengths/Depths: Length of Upper Arm Segment 10 Olecranon, Rear* Breadth/Width: Elbow Clearances Lengths/Depths: Proximal point for Length of Forearm, Forearm...
-
Clearance: ADA Standard Section 607.2
Section 607.2 covers the current ADA Standards for bathtub clearances.
-
11B-805.2.2 Beds
A 36 inch (914 mm) minimum wide clear space shall be provided along the full length of each side of the beds. [2010 ADA Standards] 805.3 Clear Floor or Ground Space....
-
Rakks® Brackets Installation Video
These brackets can be specified and made to order in any useable length up to 24”. Depending on length and load capacities, brackets are manufactured in 1-1/4” and 2” heights....
-
Salsbury Industries 66016 Standard Metal Locker with Box Style Bridge
Requires the Registered User plan or above. Login! -
M303.2.3 Wheelchair Spaces / Depth of Wheelchair Spaces for front or Rear Entry
Exceptions Considered for Wheelchair Spaces on Raised Platforms M303.2.2 Proposed Exception: The exception to the minimum width in M303.2.2 would apply where ramped surfaces are provided...
