Compatible with all accessible voting systems and voting booths. 23.25” chair width is optimal dimension to fit under 32” required minimal ADA clearance space under voting booths...
Search Results "Knee Clearance"
Filters
Commonly Searched Documents
-
Inclusion Solutions Voting Booth Accessories Franklin Voting Chair
-
1009.4.1 Clear Deck Space
Where two grab bars are provided, the clear deck space shall be centered on the clearance between the grab bars. Figure 1009.4.1 Clear Deck Space at Transfer Walls...
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at 2013 CBC 11B-806.2.3.1 is not required by 2010 ADAS....
-
Single-User Toilet Rooms: No Side Transfer Space
Door clearances and turning space, as shown in the preceding examples, further determine minimum room dimensions....
-
Is there a minimum distance between changes in level?
Ramps and curb ramps, which must be used to span vertical changes greater than ½”, must have level landings and clearances at the tops and bottoms of each run to provide adequate separation...
-
Protrusion Limits [§307.2]
Those with leading edges that are within cane sweep (27” high maximum) or that provide minimum headroom clearance (80” minimum) do not pose hazards and can protrude any amount....
-
§ 38.23(a) General
., lift or ramp) complying with paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a securement location....
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at CBC 11B-806.2.3.1 is not required by 2010 ADAS....
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at CBC 11B-806.2.3.1 is not required by 2010 ADA Standards....
-
Gurney Accessible Bathroom
standard height toilet in the shower for use as a seat or to use with a shower wheelchair for clean up after bowel/bladder program Wall mounted “P” trap for the sink (to clear the knee...
-
201.1 Scope
Modifying a practice of buying tables with insufficient knee clearances when compared to the Standard for fixed tables would likely be considered reasonable....
-
4. Organization of Technical Criteria
designed for use with a seat Weight scales designed for use with a seat Seated in a wheelchair (M303) Wheelchair space, including orientation, width, depth, knee...
-
A & M Hardware, Inc. Mounting Bracket
visible fasteners No tools required to remove & reinstall skirt Mounting holes provided for skirt if you do not wish to use spring clips 3x3 cut out for wall cleat & wire run clearance...
-
Delta Two Handle Widespread Lavatory Faucet 3553LF
deck to spout Stream straightener Metal lever handles Metal push pop-up 1/2" IPS connection 1 1/8" max. deck thickness RP10612 adds 1" to max. deck thickness Min. 2 1/2" clearance...
-
American Standard Ovalyn™ Universal Access Undercounter Sink
This special version of our Ovalyn™ under counter sink has a smaller scale, shallower sloped bowl and a rear overflow to allow greater barrier-free clearance underneath the countertop....
-
Automatic Doors
Provisions in section 404.3 address clear width; maneuvering clearance; thresholds; doors and gates in series; operable parts; break out opening; and revolving doors, gates, and turnstiles...
-
F. Chapter 5: Doorways, Circulation Paths, and Fare Collection Devices
Additionally, in the final rule, the technical requirements for vertical clearances at doorways with lifts or ramps and for illumination at doorway areas have been restated using text in...
-
604 Water Closets and Toilet Compartments
Revisions to the requirements for water closets concern: location (604.2) clearance (604.3) grab bars (604.5) flush controls (604.6) dispensers (...
-
Raised and Braille Characters on Hoistway Entrances [4.10.5]
Recommendation:Since Braille characters can be difficult to read if placed too close to raised characters, consider a vertical clearance of at least 3/8 inch....
-
Doors and Gates Operated Only By Security Personnel [§404.1, Ex]
, such as guards in a jail or prison, are exempt from requirements for hardware, closing speed, and opening force, but must meet all other requirements, including those for maneuvering clearance...
-
EXHIBIT A Required Accessible Elements at QuikTrip Stores
All objects that protrude from surfaces or posts into circulation paths shall comply with ADA Standards § 4.4 and a minimum 80 inch vertical clearance shall be provided in walks, halls,...
-
Steelcase Series 5 Height-Adjustable Work Surface
Overhanging work surfaces allow for storage outside the legs while increasing knee space inside....
-
11B-226.1 General
Consider work surfaces that are flexible and permit installation at variable heights and clearances. ◼...
