Exception: A 39-inch (991 mm) length is acceptable at interior doors when a minimum clear opening width of 34 inches (864 mm) is provided. _|Exception 2 deleted|_...
Search Results "Stroke Width"
-
1132A.5.1 General
-
1017.5 Tread Obstacles
Where possible, tread obstacles that cross the full width of the trail tread should be separated by a distance of 48 inches (1220 mm) minimum....
-
What do you call a reroute?
Are you significantly changing the overall trail grade, width, or surface, or adding bridges where the trail used to ford streams or rivers?...
-
4.3.11.2 Size
The area of rescue assistance shall not encroach on any required exit width....
-
1017.5 Tread Obstacles
Where possible, tread obstacles that cross the full width of the trail tread should be separated by a distance of 48 inches (1220 mm) minimum....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
11B-608.2.2 Standard roll-in type shower compartments
shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides with a full opening width...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
- GE® 30" Free-Standing Electric Range JB450RFSS
-
Boat Slips: ADA Standard Section 235.2
Section 235.2 covers scoping requirements in the current ADA Standards for boat slips.
- Don-Jo Mfg., Inc. Vertical Rod Protector 83
- Takeform Fusion Signage Overheads Type C.2
- Häfele America Co. Soap Dispenser Stainless Steel
- Häfele America Co. Paper Towel Waste Bin Wall Mounted
-
1002.4.4.2 Side Entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
Submerged Depth
Landings must be a minimum of 36 inches in width and 60 inches in length. The sloped entry may be a maximum of 30 feet at 1:12 (8.33%) slope before an intermediate landing is required....
-
5.3.3 Transfer Sides Recommendations for M302
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Edge Protection
Recommendation: At narrow routes in particular, consider maintenance of adjacent surfaces as raised or flush or wider route widths in consideration of minimum maneuvering and passage requirements...
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...
-
Floor Plan of Elevator Cars [4.10.9]
In alterations, smaller car sizes (minimum 47 inch width and 69 inch length) are permitted in cases of technical infeasibility, including where limited by existing shaft configurations (...