Q4: When a road alteration project triggers the requirement to install curb ramps, what steps should public (State or local) entities take if they do not own the sidewalk right-of-way needed...
Search Results "Ramp Surface"
Filters
Commonly Searched Documents
-
Q4: Road Alteration Projects that Trigger Curb Ramp Improvements Not on State/Local Property
-
Kee Safety Inc. ADA Safety Handrail Components
ADA Safety Handrail Components Kee® Access Railing System was designed specifically to equip architects, engineers, specifiers, builders, and contractors with the components...
-
11B-405.7.5 Doorways
Advisory 11B-405.7.5 Doors at ramp landings....
-
T302.2 Slip Resistant
Walking surfaces shall be slip resistant....
-
§ 35.151(b)(4)(ii)(A)
(A) An accessible path of travel may consist of walks and sidewalks, curb ramps and other interior or exterior pedestrian ramps; clear floor paths through lobbies, corridors, rooms, and...
-
§ 35.151(b)(4)(ii)(A)
(A) An accessible path of travel may consist of walks and sidewalks, curb ramps and other interior or exterior pedestrian ramps; clear floor paths through lobbies, corridors, rooms, and...
-
Carpet [4.5.3]
Carpeting can significantly increase the amount of force needed to propel a wheelchair over a surface....
-
SuperDeck Nature Trail
Superdeck Features + Benefits: ADA, DNR, US Army Corp of Engineers & Coast Guard complied requirements Low-maintenance, no-bounce, non-skid, color-stabilized polyethylene surface...
-
3 [§ 4.3.7]
3 [§ 4.3.7] The cross slope of the curb ramp is perpendicular to the running slope. Unlike the running slope, which runs along the ramp, the cross slope is measured across the ramp....
-
1005.3.2 Extended Ground or Deck Surface
1005.3.2 Extended Ground or Deck Surface. The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
Segno ADA Table #3521
Outdoor/Indoor Table. FEATURES: H 30" x W 38" x D 24" E-coated powder coat finish Made in Italy Top: Solid Steel Base: Square Steel Legs Assembly Required: Yes
-
403.1 General
Walking surfaces that are a part of an accessible route shall comply with 403....
-
403.1 General
Walking surfaces that are a part of an accessible route shall comply with 403....
-
T404.3 Ramps and Bridgeplates
platform is greater than 2 inches (51 mm) horizontally or 5/8 inch (16 mm) vertically when measured at 50 percent passenger load with the vehicle at rest, non-rail vehicles shall provide ramps...
-
11B-403.1 General
Walking surfaces that are a part of an accessible route shall comply with Section 11B-403....
-
403.1 General
Walking surfaces that are a part of an accessible route shall comply with 403....
-
11B-403.1 General
Walking surfaces that are a part of an accessible route shall comply with Section 11B-403....
-
11B-403.1 General
Walking surfaces that are a part of an accessible route shall comply with Section 11B-403....
-
5.2.3 Transfer Surface Measurement
5.2.3 Transfer Surface Measurement. The transfer surface should be measured from the center-point of each side of the transfer surface....
-
4.1.2(4)
(4) Ground surfaces along accessible routes and in accessible spaces shall comply with 4.5....
-
4.9.4(4)
(4) Gripping surfaces shall be uninterrupted by newel posts, other construction elements, or obstructions....
-
4.1.1(4)
(4) Ground surfaces along accessible routes and in accessible spaces shall comply with 4.5....
-
5.8.1.2.1 Ramped Entry Slope Recommendations
5.8.1.2.1 Ramped Entry Slope Recommendations The Committee recommends that raised platforms have a ramp with slopes that do not exceed the following: At 0 to 1½ inches, the slope...
-
Islands [§406.7]
Islands [§406.7] A 48” min. long separation is necessary between curb ramps so that people using wheelchairs can clear one ramp before negotiating the next....
