Any raised islands in crossings shall be cut through level with the street or have curb ramps at both sides and a level area at least 48 in (1220 mm) long in the part of the island intersected...
Search Results "Curb Ramp"
Commonly Searched Documents
-
4.7.11 ISLANDS
-
Issue 14: Inspection of contractor’s work - Beware of field changes!
Figure 18: APS and curb ramps that were not installed as designed. Figure 19: Another view of the same corner....
-
11B-206.2.1 Site arrival points
[ADA Title II] §35.151(i) New Construction and Alterations; Curb Ramps....
-
11B-206.2.1 Site arrival points
[ADA Title II] §35.151(i) New Construction and Alterations; Curb Ramps....
-
11B-705.1.1.4 Resiliency
Exception: Detectable warning surfaces at curb ramps, islands or cut-through medians shall not be required to comply with Section 11B-705.1.1.4....
-
2. Redressability
With regard to curb ramps, Kirola seeks an injunction requiring the City to, within ten years of judgment, construct an accessible curb ramp at every existing or potential curb ramp location...
-
11B-303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). ...
-
Conventional Strollers
These strollers are fairly difficult to maneuver over curbs, so the installation of curb ramps in the public right of way is valuable to these users....
-
R302.3 Continuous Width
Except as provided in R302.3.1, the continuous clear width of pedestrian access routes shall be 1.2 m (4.0 ft) minimum, exclusive of the width of the curb....
-
Section 2. Accessible route
Interior accessible routes may include corridors, floors, ramps, elevators and lifts. Exterior accessible routes may include parking access aisles, curb ramps, walks, ramps and lifts....
-
§100.201 Accessible route
Interior accessible routes may include corridors, floors, ramps, elevators, and lifts....
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
At curb ramps and blended transitions, detectable warning surfaces must extend the full width of the ramp run (excluding flared sides), blended transition, or turning space....
-
Location
Devices must be located a minimum of 3m (10 feet) apart, no more than 3m (10 feet) maximum from the curb line (and closer, if possible), and between the curb ramp landing and the outside...
-
R208.1 Where Required
Curb ramps and blended transitions at pedestrian street crossings; 2. Pedestrian refuge islands; 3....
-
303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). Figure 303.3 Beveled Change in Level ...
-
R302.6 Cross Slope
Cross slope requirements are contained in R304.5.3 for curb ramps and blended transitions, and in R407.3 for ramps....
-
Slope [4.3.7]
Where the running slope of an accessible route exceeds 5% it must be treated as a ramp or curb ramp. A maximum cross slope of 2% is recognized for drainage....
-
13) Detectable warnings
13) Detectable warnings ADAAG: Required on curb ramps, hazardous vehicular areas, and reflecting pools, but not on doors to hazardous areas....
-
LaCantina Contemporary Clad Door System Ramp Sill
Requires the Premium User plan or above. (Login or upgrade your account!)
-
LaCantina Aluminum Wood Slider System Ramp Sill
Requires the Premium User plan or above. (Login or upgrade your account!)
-
LaCantina Aluminum Slider System ADA Ramp Sill
Requires the Premium User plan or above. (Login or upgrade your account!)
-
Q13: Specific Requirements for Road Alteration Projects by Public Entities that Receive Federal Financial Assistance
At that time, DOT’s regulation adopted a modification to Section 406 of the 2004 ADAAG which required the placement of detectable warnings on curb ramps. ...
-
Solutions for Accessibility: Problems Involving Ramps
[See subsections ...]
-
11B-303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). FIGURE 11B-303.3 BEVELED CHANGE IN LEVEL...