Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
Search Results "Transfer Wall"
-
608.3.2 Standard Roll-In Type Shower Compartments
-
11B-604.5 Grab bars
Grab bars shall be provided on the side wall closest to the water closet and on the rear wall....
-
11B-604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
704.11 Parapets
Parapets shall be provided on exterior walls of buildings. Exception: A parapet need not be provided on an exterior wall where any of the following conditions exist: 1....
-
409.4.6.2 Location
Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall....
-
11B-409.4.6.2 Location
Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall....
-
11B-409.4.6.2 Location
Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall....
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
11B-610.3.2 L-shaped seats
The rear edge of an L-shaped seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall....
-
11B-407.4.10.1 Location
The ends of the support rail shall be 6 inches (152 mm) maximum from adjacent walls....
-
11B-407.4.10.1 Location
The ends of the support rail shall be 6 inches (152 mm) maximum from adjacent walls....
-
Water Closet Location and Rear Grab Bar
Section 604.5.2, Exception 1 permits a shorter grab bar on the rear wall where there is not enough wall space due to special circumstances (e.g., when a lavatory or other recessed fixture...
-
608.3.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
11B-608.3.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
Dissemination activities
The impact of transfer setup on the performance of independent transfers, Human Factors: The Journal of the Human Factors and Ergonomics Society, in press....
-
Bobrick Koala Kare Horizontal, Stainless Steel Wall Mounted Baby Changing Station KB110-SSWM
Model Number: KB110-SSWM Koala stainless steel clad surface mounted horizontal baby changing station with polyethylene interior. Full length steel-on-steel hinges with 11 gauge...
-
Protocol B Heights Obtained
Again for the minimum height protocol HERL participants transferred lower on average than the NDVWSC participants....
-
11B-608.3.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
610.3.2 L-Shaped Seats
The rear edge of an L-shaped seat shall be 2 1/2 inches (64 mm) maximum and the front edge 15 inches (380 mm) minimum and 16 inches (405 mm) maximum from the seat wall....
-
1134A.5, Item 2
Reinforced walls for grab bars. A bathtub installed without surrounding walls shall provide reinforced areas for the installation of floor-mounted grab bars....
-
11B-604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
1134A.5, Item 2
Reinforced walls for grab bars. A bathtub installed without surrounding walls shall provide reinforced areas for the installation of floor-mounted grab bars....
-
11B-604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
11B-604.5 Grab bars
Grab bars shall be provided on the side wall closest to the water closet and on the rear wall....
