(6) Platform surface. The lift platform surface shall be free of any protrusions over 1/4 inch high and shall be slip resistant....
Search Results "Kitchen Work Surface"
Commonly Searched Documents
- 
    
  
  § 38.95(b)(6) Platform surface
  
 - ACCESSMAT® - EN - Beach accessibility mats
 - 
    
  
  I. Introduction to the Study
  
In addition, the ground surface must meet the ASTM F1951‒99 Standard Specification for Determination of Accessibility of Surface Systems Under and Around Playground Equipment. ...
 - Sears Brands, LLC Craftsman 10 in. Digital LaserTrac® Level
 - 
    
  
  How to Measure Transfer Surface Height
  
How to Measure Transfer Surface Height Regardless of the final decision on the low height measurement, the Subcommittee agreed that the height of the transfer surface would be measured...
 - 
    
  
  ADA Gap Tool
  
ADA Gap Tool This handy tool was developed by Evan Terry Associates to assist its surveyors in measuring gaps in ground or floor surfaces....
 - 
    
  
  3.3 Guidance on the Visual Properties of Detectable Warnings
  
Two relatively dark surfaces may provide high luminance contrast, but on asphalt or other dark sidewalk surfaces (with reflectance less than 10 percent) high contrast is not always a good...
 - 
    
  
  Hologic, Inc.
  
Prone breast biopsy tables were considered by the “Imaging Equipment with Transfer Surfaces” sub-committee and are described in Section 4.3.2 of the full committee report....
 - 
    
  
  11B-1008.2.6.2 Use zones
  
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition)....
 - 
    
  
  11B-1008.2.6.2 Use zones
  
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition)....
 - 
    
  
  11B-1008.2.6.2 Use zones
  
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition)....
 - 
    
  
  M305.2.5 Surface Hazards
  
Transfer supports and surfaces adjacent to transfer supports shall be free of sharp or abrasive components and shall have eased edges....
 - 
    
  
  Tread
  
Tread—The portion of a trail, outdoor recreation access route, or beach access route where traffic moves (for pedestrian routes, this is the walking surface)....
 - 
    
  
  § 38.79(a)
  
(a) Floor surfaces on aisles, step treads, places for standees, and areas where wheelchair and mobility aid users are to be accommodated shall be slip-resistant....
 - Mobi-mat® Recpath Demonstration Video
 - Mobi-Mat® installation
 - Access Board: Accessible Route Openings
 - Pilot Rock APTX Full Sized Pedestal Rectangular Utility Tables Using Recycled Plastic
 - Pilot Rock APTX Full Sized Pedestal Rectangular Utility Table Using Lumber
 - 
    
  
  Resting Intervals [1016.8]
  
., as flat as possible) so that all the wheels of a mobility device touch the ground surface when turning into and out of the resting interval....
 - 
    
  
  1008.2.6.2 Use Zones
  
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)....
 - 
    
  
  23. How should an employer handle requests for modified or part-time schedules for an employee covered by both the ADA and the Family and Medical Leave Act (FMLA)?
  
health plan during the period of FMLA leave, provided the employee pays his/her share of the premium.(70) Example: An employee with an ADA disability requests that she be excused from work...
 - Pilot Rock APTX Full Sized Pedestal Rectangular Utility Tables
 - 
    
  
  7.4.3.2 Cross Slope
  
Where the surface is paved or is elevated above the natural ground, the cross slope shall not be steeper than 1:48 (2 percent). ...