The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
Search Results "Curb Ramp Surface"
Filters
Commonly Searched Documents
-
403.3 Slope
-
Tread Obstacles [1017.5]
A tread obstacle is anything that interrupts the evenness of the tread surface....
-
Non Slip Safety Solutions
The end result is a floor surface engineered for lasting beauty and trouble-free maintenance....
-
11B-403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
11B-403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
T402.7 Edge Guards
Ramps and bridgeplates shall provide edge guards continuously along each side of the ramp or bridgeplate to within 3 inches (75 mm) of the end of the ramp or bridgeplate that is deployed...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
A4.8.1 General
Ramps are essential for wheelchair users if elevators or lifts are not available to connect different levels....
-
A4.8.1 GENERAL
Ramps are essential for wheelchair users if elevators or lifts are not available to connect different levels....
-
A4.8.4 Landings
A ramp landing that is not level causes individuals using wheelchairs to tip backward or bottom out when the ramp is approached....
-
1011.5.2 Cooking Surfaces
Where provided, cooking surfaces shall be 15 inches (380 mm) minimum and 34 inches (865 mm) maximum above the ground....
-
1011.5.2 Cooking Surfaces
Where provided, cooking surfaces shall be 15 inches (380 mm) minimum and 34 inches (865 mm) maximum above the ground....
-
UltraPlay Recycled Rubber Tile Surface
Allows for individual tile replacement Superior shock absorption characteristics Provide a guaranteed critical fall height value Is a good solution for playgrounds erected on a smooth surface...
-
R409.1 General
Handrails required at ramps and stairways, and handrails provided on pedestrian circulation paths shall comply with R409. Advisory R409.1 General....
-
WoodCarpet Ground Surface System: WoodCarpet Mat Installation Video
-
3.2.4 Slope
The ground surface in all camp living areas shall have a slope of no more than 1:48 (2 percent) in any direction. Exception....
-
NanoPave® 2-in-1 Joint Stabilizer and Sealer
NP-JSS is a UV resistant, VOC-free sealant that protects and helps maintain the natural beauty of most paving surfaces....
-
Problem Two (Accessible Route)
Problem Two: The accessible route crosses a curb and no curb ramp is provided. Solution: Install a portable ramp....
-
11B-302.3 Openings
Openings in floor or ground surfaces shall not allow passage of a sphere more than ½ inch (12.7 mm) diameter except as allowed in Sections 11B-407.4.3, 11B-409.4.3, 11B-410.4, 11B-810.5.3...
-
Maximum Slope at Ground Level
A berm may be a natural sloped surface that is present in a hilly play area site, or a ground-level route built with slopes....
-
(3) Adjustability: Transfer Surface Intermediate Heights
In the MDE NPRM there was no requirement for the transfer surface to have intermediate transfer heights....
-
Cross Slope (R302.6) (Section-by-Section Analysis)
On a sidewalk, cross slope is measured perpendicular to the curb line or edge of the street or highway....
-
Performance and the Surface Deficiency Score
In an effort to statistically analyze the frequency of identifiable deficiencies between surface types, the Surface Deficiency Score (SDS) was developed. ...
