M302.2.3 Transfer Sides Proposed requirement: The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width...
Search Results "Continuous Width"
Filters
Commonly Searched Documents
-
M302.2 Transfer Surface
-
1003.3 Clearances
Although the minimum width of the clear pier space is 60 inches (1525 mm), it is recommended that piers be wider than 60 inches (1525 mm) to improve the safety for persons with disabilities...
-
R207.1 General
The curb ramp (excluding any flared sides) or blended transition shall be contained wholly within the width of the pedestrian street crossing served....
-
1008.2.6 Ground Surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
§382.133(f)
in paragraphs (f)(1) through (7) of this section upon inquiry from an individual concerning the use in the cabin during air transportation on such a flight of a ventilator, respirator, continuous...
-
505.10.2 Top Extension at Stairs
Extensions shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent stair flight....
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
Accessible Route
A continuous unobstructed path connecting all accessible elements and spaces of a building or facility....
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
Wheelchair Spaces
Wheelchair spaces may be placed side-by-side, as reflected in specifications for width that are specific to adjoining spaces....
-
Passing Spaces [1016.4]
Where the clear width of an ORAR is less than 60 inches, passing spaces must be provided at intervals of at least 200 feet....
-
DETR
Width was the unoccupied width. Height was taken from the ground to the highest point, either chair or person....
-
American Safety Tread Co., Inc. Type G4702 Stairway Nosing Replacement
Width: 5" Lip: 1-3/8" at 90° angle Thickness: 1/4" Anchor Options: Drilled for screws. Standard Width: 5"...
-
Q3: Roadway Resurfacing Alteration Project and Curb Ramp Improvements
Q3: If a roadway resurfacing alteration project does not span the full width of the road, do I have to put in curb ramps?...
-
Tread Obstacles [1017.5]
Frequent tread obstacles and tread obstacles that cross the full width of a trail tread can make travel very difficult for people using mobility devices....
-
T-turn Maneuvering Space
The Guidelines adequately address the accessible route into and through the dwelling unit by the minimum corridor width and door width specifications, given typical apartment layouts....
-
Alterations: Alternate Stalls
Alternate designs in ADAAG Figure 30(b) allow narrower stall widths while requiring greater depth....
-
1134A.7, Item 1
The minimum floor space provided at a water closet shall be 48 inches (1219 mm) in clear width....
-
Wagner Instruments Mark-10 M3 Digital Force Gauge
Programmable set points continuously display. 2000 Hz peak sampling of rapid occurring events. Construction Large backlit 5 digit graphic display....
-
1003.3 Clearances
Although the minimum width of the clear pier space is 60 inches (1525 mm), it is recommended that piers be wider than 60 inches (1525 mm) to improve the safety for persons with disabilities...
-
M301.2.3.1 End Transfer Surface
EXCEPTION: Transfer surfaces for imaging equipment with bores shall be permitted to be 21 inches (535 mm) wide minimum but shall not be permitted to be less than the full width of the examination...
-
M301.2.3.2 Side Transfer Surface
EXCEPTION: Transfer surfaces for imaging equipment with bores shall be permitted to be 21 inches (535 mm) wide minimum but shall not be permitted to be less than the full width of the examination...
-
404.2.4 Maneuvering Clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance....
