Where the determination of the required size or dimension of an element or facility involves ratios or percentages, rounding down for values less than one half is permitted....
Search Results "Permit"
-
R103.2 Calculation of Percentages
-
E101.2 Equivalent Facilitation
greater accessibility and usability by individuals with disabilities than would be provided by conformance to one or more of the requirements in Chapters 4 and 5 of the 508 Standards is permitted...
-
C101.2 Equivalent Facilitation
greater accessibility and usability by individuals with disabilities than would be provided by conformance to one or more of the requirements in Chapters 4 and 5 of the 255 Guidelines is permitted...
-
Scoping [4.1.3(5)]
occupancies wheelchair seating locations in assembly occupancies incidental space or rooms not open to the public with a maximum occupancy of five Platform lifts are also permitted...
-
4.1.6(4)(d)
(i) Where existing elements prohibit strict compliance with the clearance requirements of 4.13.5, a projection of 5/8 in (16 mm) maximum will be permitted for the latch side door stop....
-
§1630.14(d)(4)(iv)
(iv) A covered entity shall not require an employee to agree to the sale, exchange, sharing, transfer, or other disclosure of medical information (except to the extent permitted by this...
-
§ 38.113(a)(2)
maximum extent practicable in accordance with regulations issued under the Federal Railroad Safety Act of 1970 (49 CFR parts 229 and 231), shall have a clear opening width of 32 inches to permit...
-
11B-409.3.1 Power operation
Exception: In elevator cars with more than one opening, hoistway doors and gates shall be permitted to be of the manual-open, self-close type....
-
§ 38.159(a)(1) General
., lift or ramp) complying with paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a securement location....
-
11B-409.3.1 Power operation
Exception: In elevator cars with more than one opening, hoistway doors and gates shall be permitted to be of the manual-open, self-close type....
-
Other Power-driven Mobility Devices (OPDMDs)
at different times of the day, week, month, or year); the facility's design and operational characteristics; whether legitimate safety requirements can be established to permit...
-
NFPA
Revise Section 12.3.8.1 as follows: 12.3.8.1 The outgoing and return (redundant) circuit conductors shall be permitted in the same cable assembly (i.e., multiconductor cable), enclosure...
-
NFPA
Revise Section 12.3.8.1 as follows: 12.3.8.1 The outgoing and return (redundant) circuit conductors shall be permitted in the same cable assembly (i.e., multiconductor cable), enclosure...
-
5. Advance Notice
Advance Notice We sought comments in the Oxygen NPRM about operational reasons, if any, in support of permitting carriers to require a passenger with a disability to provide advance notice...
-
11B-407.4.8.2.1 Signal type
per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz maximum which sounds as the car passes or is about to stop at a floor served by the elevator shall be permitted...
-
§382.129(a)
(a) As a carrier, you must permit passengers with a disability to provide written directions concerning the disassembly and reassembly of their wheelchairs, other mobility aids, and other...
-
11B-306.3.4 Clearance reduction
Between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
11B-407.2.1.1 Height
[2010 ADAS] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
-
M305.2.1 Location
EXCEPTION: Where the support folds, collapses, or articulates, the transfer support shall be permitted to be located 3 inches (75 mm) maximum from the plane defined by the nearest edge of...
-
11B-612.2 Bench
Exception: A readily removable bench shall be permitted to obstruct the turning space required by Section 11B-612.3 and the clear floor or ground space required by Section 11B-903.2....
-
M301.4 Lift Compatibility
EXCEPTION: Where fixed overhead patient lifts are provided, and when their use with diagnostic equipment is permitted by an enforcing authority, diagnostic equipment shall not be required...
-
M302.4 Lift Compatibility
EXCEPTION: Where fixed overhead patient lifts are provided, and when their use with diagnostic equipment is permitted by an enforcing authority, diagnostic equipment shall not be required...
-
1013.1 General
EXCEPTION: When an entity determines that a condition in 1019 does not permit full compliance with a specific provision in 1013, the tent pad and tent platform shall comply with the provision...
-
405.5 Clear Width
EXCEPTION: Within employee work areas, the required clear width of ramps that are a part of common use circulation paths shall be permitted to be decreased by work area equipment provided...